Sony DAV-HDX587WC Operating Instructions Manual page 31

Setting the type of video
output to match your TV
Depending on the connection of the TV
(page 22), select the type of video output of the
system.
To select the type of video signal
output from the HDMI OUT jack
When you connect the unit and the TV with an
HDMI cable, select the type of video signals
output from the HDMI OUT jack.
For details, refer also to the operating
instructions supplied with the TV/projector, etc.
1
Press FUNCTION +/– repeatedly until
"DVD" appears in the front panel
display.
2
Press DISPLAY while the system is
in stop mode.
The Control Menu display appears on the
TV screen.
3
Press X/x to select
then press .
The options for [SETUP] appear.
4
Press X/x to select [CUSTOM], then
press .
The Setup Display appears.
5
Press X/x to select [HDMI SETUP], then
press .
The options for [HDMI SETUP] appear.
6
Press X/x to select [HDMI
RESOLUTION], then press
7
Press X/x to select the desired setting,
then press .
• [AUTO (1920 1080p)]: The system
×
outputs the optimal video signal for the
connected TV.
• [1920 1080i]: The system outputs 1920
×
× 1080i* video signals.
• [1280 720p]: The system outputs 1280 ×
×
720p* video signals.
• [720 480p]**: The system outputs 720 ×
×
480p* video signals.
* i: interlace, p: progressive
Does your TV accept progressive
signals?
Progressive is a method for displaying TV
images which reduces flickering and sharpens
the image. To use this method, you need to
connect to a TV that accepts progressive signals.
1
2
3
4
5
[SETUP],
6
7
.
** Depending on the area, [720 × 480/576p] may
appear.
Press FUNCTION +/– repeatedly until
"DVD" appears in the front panel
display.
Press DISPLAY while the system is
in stop mode.
The Control Menu display appears on the
TV screen.
Press X/x to select
then press .
The options for [SETUP] appear.
Press X/x to select [CUSTOM], then
press .
The Setup Display appears.
Press X/x to select [VIDEO SETUP],
then press .
The options for [VIDEO SETUP] appear.
Press X/x to select [PROGRESSIVE
(COMPONENT OUT)], then press
Press X/x to select the desired setting,
then press .
[OFF]: The system does not output
progressive signals. Select this setting
when:
– your TV does not accept progressive
signals, or,
– your TV is connected via jacks other than
the COMPONENT VIDEO OUT jacks.
[ON]: The system outputs progressive
signals. Select this setting when:
– your TV accepts progressive signals,
and,
– the TV is connected via the
COMPONENT VIDEO OUT jacks.
When you select [ON], the confirmation
display appears. Follow the Steps below.
[SETUP],
.
31
US