Advertisement
BC51 Mount & Connect
Loosen but do not remove the
1
four screws on the mount plate.
For drywall, drill three 7/16 inch holes and
4
insert the drywall anchors into the holes.
Fasten the mount plate onto the wall by
installing the flat head mounting screw
into the top wall anchor and the round
head mounting screws into the bottom
two wall anchors.
Peel the protective lm o of
6
the adhesive strip and place
the iPad into the mount.
Tighten all four screws with the
9
2.5mm ball head hex key tool to
secure the mount front cover.
Slide the front cover o of the
2
mount plate.
For a solid material, like wood or
metal, drill three 5/32 inch pilot holes.
Fasten the mount plate onto the wall
by installing the flat head mounting
screw into the top pilot hole and the
round head mounting screws into
the bottom two pilot holes.
Press rmly on the iPad for 8
7
seconds to adhere it to the mount.
After connecting BC51 to
802.3af/802.3 at Power over
Ethernet (PoE) port on your
network, visit
www.verkada.com/start
For detailed installation
instructions, visit
www.verkada.com/support
Remove the iPad from the
3
mount plate and set it aside.
Connect the PoE adapter to
5
your network using the ethernet
port located on the mount. Plug
the lightning cable into the iPad
and check connectivity.
Place the mount front cover so that
8
screws insert into the circular holes
in the mount plate, then slide the
front cover up so screws are in the
narrow section of the slot.
Advertisement
