Zipato KNX Manual

The KNX Expansion module for Zipabox serves as a simple integration solution for KNX devices.
The device supports the BAOS protocol for accessing data points. This allows KNX devices to be fully integrated into
a Zipato network via standard KNX bus.
COMPATIBILITY
This expansion module is designed to work only with Zipabox.
HANDLING
Do not drop, knock or shake the module. Rough handling can break internal circuit boards and connectors.
ENVIRONMENT
Do not expose the module to excessive heat or cold, as it can damage or shorten the life of electronic circuit boards.
If possible, dispose this module at a recycling center. Do not dispose of this module with the household waste.
SPECIFICATION
Electrical safety
• Protection classification (EN 60529): IP 20
• Safety extra low voltage SELV DC 30 V
• Galvanic isolation: 2,5 kV DC
EMC requirements
• Complies with EN 50090-2-2 and EN 50491-5-2 CE
norm
• Complies with the EMC regulations (residential and
functional buildings) and low voltage directive
Certification
• KNX
Environmental requirements
• Ambient temp. operating: - 5 ... + 45 ° C
• Ambient temp. Non-op.: - 25 ... + 70 °C
• Rel. humidity (non-condensing): 5 % ... 93 %
Mechanical data
• Housing: Plastic
UNPACKING
KNX expansion module consists of:
1x expansion module
1x user manual
CONNECTING TO THE ZIPABOX
1. Disconnect Zipabox from power;
2. Align connector of KNX expansion module to
expansion Slot 2 of Zipabox (or to module
connected into Slot 2);
KNX expansion module
FOR ZIPABOX
• DIN rail mounted device, width: 18 mm
• Weight: approx. 45 g Indicator
• Signal-LED (green) for KNX-Connection Power
supply
• The device is supplied by KNX bus.
• Current consumption: ca. 10 mA
Connectors
• KNX: KNX connector
• RS-232: SUB-D connector (female, 9 pole), cable
length max. 5 m
Protocol
• UART (19,2 kbit/s, 8 data bits, parity even, 1 stop
bit)
• Frame Format: FT1.2 (IEC 870-5-1 and 870-5-2)
• Protocol telegrams: EMI2
• Protocol Data points: BAOS Binary V1
Up to 250 group objects and 250 parameters
3. Join module and Zipabox together until gap
between them is completely closed.