Rh-34 Display Assembly - Nokia RH-34 Series Technical Documentation Manual

RH-34
Troubleshooting - Antennas

RH-34 Display Assembly

Grounding of the display shield and frame
Grounded
position
Display Frame
plated area
Display
Frame
The display shield is connected to the display frame plated area (screw boss area) and
then to the PWB through the two top screws. The grounding of the display shield and
frame will impact the radiation performace of the phone. If the screws are loose, then
tighten them. If the screw bosses are stripped, then the chassis will need to be replaced.
If the screws are missing, install new ones.
If the display frame plated area is cracked or the metal plating has peeled off, then the
gounding of the display shield and frame will not be guaranteed. Replace the frame.
Page 8
Display
shield
Figure 8: RH-34 phone display assembly
Figure 9: Side view of RH-34 display assembly
©2003 Nokia Corporation
CCS Technical Documentation
Display
shield
Confidential Issue 1 11/2003