Advertisement
Basic Operation
Power supply to switch on/off this Unit.
Before switch on, ensure that all connections will be proper
and
correct.Press the Key at the bottom of the panel of this
Unit to turn on this Unit.Press the Key to show Menu and
select Power Logo to turn off this Unit.When the power
indicator turns red, this Unit accesses standby state.
Press
key to start this Unit.The power indicator turns
Press
key once again to switch off this Unit.
If there is no signal for the current signal source, this unit will
automatically set to the standby state
If not to use the main Unit for a long time, unplug the AC
power cord from the AC outlet.
Select input signal sources
After turn on the main unit, press source to select proper input
source. Press ▼/▲ button to select the main signal source.
Press OK button to confirm.
Setting the OSD Menu
Press MENU button, and the main menu appears. the main
menu display in turn as below:
Picture→Sound→Channel→Lock→Time→Setting
When display of some menu option is gray, it indicates that
such options are not available under the current mode.
General Step for Menu Setup:
For each main menu, first press OK button to enter the
submenu.
Press ▲/▼ button to select the desired adjustable option.
Press ◀/▶ button to adjust to suitable value.
After the selection of option is completed, press Menu
button to be able to quit the menu.
Installation Guide
The installation guide only appear when the TV first time turn
on or reset to factory set .
Language Setting
off.
15
minutes later.
-11-
Press ▲/▼ button to navigate the menu and change the
settings. Select your desired language to be displayed on
the menu. Press ▶button to next.
LOCK Password
Input your password and press Confirm to complete.
Note: The default password is 0000
Network Setting
Press ▼/▲ button to select Wi-Fi and press the OK button.
Input password and Press ▼ button to select Connect and
then press the OK button. Press ▶ button to next . If you
want to back ,press ◀ button.
Auto Scan
Press ◀/▶ button to select Country.
Press ◀/▶ button to select Air / Cable.
Press ◀/▶ button to select Analog / Ditigal.
If set success , Select Start Scan button and Press OK button.
Channel tuning will commence. This operation may take
up to some minutes. The display will show the progress of
the tuning and the number of channels found.
TV OPERATION
Thailand
Advertisement
