Buick 2011 Lucerne Owner's Manual page 238

needs to be reactivated. Contact XM at
www.xmradio.com or call 1-800-929-2100 in the U.S.
and www.xmradio.ca or call 1-877-438-9677 in Canada.
There are no channels available for
the selected category. The system is working properly.
The XM receiver in the vehicle could
have previously been in another vehicle. For security
purposes, XM receivers cannot be swapped between
vehicles. If this message is received after having the
vehicle serviced, check with your dealer.
If tuned to channel 0, this message
alternates with the XM
This label is needed to activate the service.
If this message is received when tuned to
channel 0, there could be a receiver fault. Consult with
your dealer.
If this message does not clear within
a short period of time, the receiver or antenna could
have a fault. Consult with your dealer.
If this message does not clear
within a short period of time, the receiver could have a
fault. Consult with your dealer.
If this message does not clear
within a short period of time, the receiver could have a
fault. Consult with your dealer.
4-82
XM subscription
Radio 8 digit radio ID label.
For vehicles with a navigation radio system, see the
separate Navigation System manual.
Vehicles with a Bluetooth system can use a Bluetooth
capable cell phone with a Hands Free Profile to make
and receive phone calls. The system can be used while
the key is in ON/RUN or ACC/ACCESSORY position.
The range of the Bluetooth system can be up to 9.1 m
(30 ft). Not all phones support all functions, and not all
phones are guaranteed to work with the in-vehicle
Bluetooth system. See www.gm.com/bluetooth for more
information on compatible phones.
The Bluetooth system uses voice recognition to
interpret voice commands to dial phone numbers and
name tags.
For additional information say Help while you are in a
voice recognition menu.
Keep interior noise levels to a minimum. The
system may not recognize voice commands if there is
too much background noise.
A short tone sounds after the system
responds indicating when it is waiting for a voice
command. Wait until the tone and then speak.