Table of Contents
Advertisement
Cleaning under the Machine
Service Interval: Before each use or daily
WARNING
The machine may dislodge material from
under the machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the motor is running.
• Do not allow bystanders in the area.
For best results, clean the machine soon after you
have completed mowing.
1.
Lower the machine to the lowest cutting-height
setting. Refer to
(page
12).
2.
Move the machine onto a level surface.
3.
Wash out the area under the rear door (if
applicable) where the clippings go from the
underside of the machine to the grass bag.
4.
Attach a garden hose that is connected to a
water supply to the washout port
Figure 23
1. Washout port
5.
Turn the water on.
6.
Start the motor and run it until there are no more
clippings that come out from under the machine.
7.
Shut off the motor.
8.
Shut off the water and disconnect the garden
hose from the machine.
9.
Start the motor and run it for a few minutes to
dry the underside of the machine.
10.
Shut off the motor and allow it to cool.
Adjusting the Cutting Height
(Figure
23).
g189103
21
Advertisement
Table of Contents
