Advertisement
pmvmounts
Mounting instructions for 50mm Pole-adapter projector mount
Fits any 50mm diameter ceiling poles.
Maximum projector fixing points up to 630mm x 325mm - Up to 25Kgs
Model No.
PMVMOUNT1PA
Pre assembled
Pole adapter
Button head bolt
M8 - 75mm
Tilt washer
Tilt lock washer
Fixing Kit
Button head screw
A -
M6 x 8mm
Screw
M3 x 10mm
M4 x 10mm
B -
M5 x 10mm
M6 x 10mm
Screw
M3 x 25mm
M4 x 25mm
C -
M5 x 25mm
M6 x 25mm
Washer
M3,
E -
M4,
M5,
M6
F - Spacer
Struts
Short,
G -
Medium,
Long
Grub Screw
H -
M6 x 8mm
Read these instructions carefully before installing your equipment.
Ÿ
Install the mount in a suitable location using fixings which are appropriate for
Ÿ
.co.uk
the ceiling material and structure. Consult a qualified builder if you're in any doubt as
to the structural integrity of the ceiling.
Do not attempt to alter or modify any part of the ceiling mount or its attachments.
Ÿ
Do not use if any parts are broken or appear to be damaged.
Ÿ
Tighten all bolts and fixings securely. Only use fixings provided with this bracket.
Ÿ
Factory No.
Do not mount your projector close to sources or heat or moisture.
Ÿ
Z0874PA
Always have a minimum of two persons to install the projector on to the mount.
Ÿ
x4
x4
x4
x4
x4
x4
x4
x4
x4
x4
x4
x4
x4
x20
x2
of each
x4
Projector mount
1
Mount Ceiling plate To Ceiling
A: Position Pole Adapter over exsisting 50mm pole
B: Insert all 4 grub screws from the fixing kit to retain the
pole adapter in position.
Note: Ceiling fixings are not supplied. Use the correct fixings
appropriate for the ceiling material and structure.
A
B
Advertisement
Table of Contents
Related Manuals for PMV Mounts PMVMOUNT1PA
Summary of Contents for PMV Mounts PMVMOUNT1PA
- Page 1 Ÿ Model No. Factory No. Do not mount your projector close to sources or heat or moisture. Ÿ PMVMOUNT1PA Z0874PA Always have a minimum of two persons to install the projector on to the mount. Ÿ Pre assembled Projector mount...
- Page 2 Attach struts to projector mount Alternative fitment... Attach projector mount and struts to all threads Note: Use the appropriately sized fixings from the fixing kit. Use spacers as required, not always necessary.
- Page 3 Attach projector mount to pole section Remove both tilt and tilt lock washers and large M8 x 75mm bolt from bottom of the Pole adapter. Position the hooks on the projector mount over the corresponding parts of the lower moulding. Continued...
- Page 4 Adjust the projector Rotation: Rotate the projector via the projector mount, the retaining bolt within the ceiling mount is torqued to stay tight but allow manual rotational adjustment. Tilt: Adjusted via the tilt locking mechanism between the pole section and projector mount. Loosen retaining bolt and tighten at desired angle.
Need help?
Do you have a question about the PMVMOUNT1PA and is the answer not in the manual?
Questions and answers