Related Manuals for Gamma Led Vision TX5 Hybrid
Summary of Contents for Gamma Led Vision TX5 Hybrid
- Page 1 TX5 Hybrid 250w Hybrid Moving Head with Zoom User Manual TX5 Hybrid – GAMMA LED Vision Page 1 of 24...
-
Page 2: Table Of Contents
1. Introduction and Setup Unpacking and In the Box Thank you for choosing our TX5 Hybrid moving head light. For your own safety, please read this manual before installing or using the device. This manual covers the important information on installation and applications. Please install and operate the fixture with following instructions. - Page 3 • TX-5 250w Moving Head – 1 • DMX Signal Cable – 1 • Power Cable – 1 • Omega Clamps – 2 • User Manual - 1 TX5 Hybrid – GAMMA LED Vision Page 3 of 24...
- Page 4 The TX5 provides a unique mounting bracket assembly that integrates Clamp Mounting: the bottom of the base, and the safety cable rigging point in one unit (see the illustration below). TX5 Hybrid – GAMMA LED Vision Page 4 of 24...
- Page 5 “omega bracket”. As an added safety measure be sure to attached at least one properly rated safety cable to the fixture using on of the safety cable rigging point integrated in the base assembly. TX5 Hybrid – GAMMA LED Vision Page 5 of 24...
- Page 6 Regardless of the rigging option you choose for your TX5 Hybrid, always be sure to secure your fixture with a safety cable. The fixture providers a built-in rigging point for a safety cable on the hanging bracket as illustrated above. Be sure to only use the designated rigging point for the safety cable and never secure a safety cable to a carrying handle.
- Page 7 • High speed strobe effect with 1-25 hz • Internal program available • 16/18 DMX Channels USITT DMX-512 • DMX 512, master-slave and sound activated controllable or auto operation • Colorful LCD display TX5 Hybrid – GAMMA LED Vision Page 7 of 24...
- Page 8 • Efficient low noise fan cooling system • PowerCon IN/OUT • 3-pin XLR connectors IN/OUT • Two 1/4 turn fastening Omega Clamps • IP 20 protection rating TX5 Hybrid – GAMMA LED Vision Page 8 of 24...
- Page 9 During initial start-up some smoke or smell or smell may arise. This is a normal process and does not necessary mean that the device is defective, it should decrease gradually. Please don’t project the beam onto combustible substances. TX5 Hybrid – GAMMA LED Vision Page 9 of 24...
- Page 10 Don’t expose the fixture in overheating, moisture or environments with too much dust when installing it. And don’t lay any power cables on the floor. Or it might cause electronics shock to the people. TX5 Hybrid – GAMMA LED Vision Page 10 of 24...
-
Page 11: Setup And Operation
Customer Support WARRANTY POLICY GAMMA LED Vision warrants its products for the periods set below from the date of purchase to be free of manufacturer and workmanship defects. Warranty does not cover normal wear and tear caused by force, negligence or misuse of products. GAMMA LED Vision is not responsible for any damages or injury caused by misuse or improper handling of the products and in accordance with instructions and specifications of manual. - Page 12 Menu Operation TX5 Hybrid – GAMMA LED Vision Page 12 of 24...
-
Page 13: Dmx Basics
32 Fixture Rule – DMX only allows you to connect up to 32 fixtures in a single daisy chain for signal strength. Sometimes, depending on the fixtures and cable length, this number is less (or more). TX5 Hybrid – GAMMA LED Vision Page 13 of 24... - Page 14 DMX Cables can be 3-pin or 5-pin. These use the same type of data, and in the 5-pin only pins 1, 2, and 3 are used. The cable should be a 2 conductor, shielded cable of at least 110 ohms resistance. Microphone cable is not DMX cable. TX5 Hybrid – GAMMA LED Vision Page 14 of 24...
- Page 15 Depending on your needs and control solution, you may not need channels for automated programs, strobes, or macros – your console may have great effects! In this case, you can use a lesser channel mode and fit more lights per DMX universe. TX5 Hybrid – GAMMA LED Vision Page 15 of 24...
- Page 16 View the DMX mode charts below to find the mode that best suits your needs. TX5 Hybrid – GAMMA LED Vision Page 16 of 24...
- Page 17 16-31 32-47 Green 48-63 Yellow 64-79 Deep Blue/Indigo 80-95 Magenta 96-111 Amber 112-127 Cyan 128-191 CW scroll, slow to fast 192-255 CCW scroll, slow to fast Color 0-10 No Function TX5 Hybrid – GAMMA LED Vision Page 17 of 24...
- Page 18 99-105 Gobo 3 Shake 106-112 Gobo 2 Shake 113-119 Gobo 1 Shake 120-127 Open 128-191 Gobo Scroll CW from Slow to Fast 192-255 Gobo Scroll CCW from Slow to Fast TX5 Hybrid – GAMMA LED Vision Page 18 of 24...
- Page 19 Gobo Scroll CW Slow to Fast 216-255 Gobo Scroll CCW Slow to Fast Focus 0-255 Soft to sharp Zoom 0-255 Narrow to Wide, 5.5°-30° Prism 0-63 Open 64-255 Prism In Prism 0-15 Stop TX5 Hybrid – GAMMA LED Vision Page 19 of 24...
-
Page 20: Maintenance
The following points have to be considered during the inspection: 1) All screws for installing the devices or parts of the device have to be tightly connected and must not be corroded. TX5 Hybrid – GAMMA LED Vision Page 20 of 24... - Page 21 There are no serviceable parts inside the device. Please refer to the instructions under “Installation instructions”. Should you need any spare parts, please order genuine parts from your local dealer. TX5 Hybrid – GAMMA LED Vision Page 21 of 24...
-
Page 22: Troubleshooting Problems
• Control Signal: DMX 512, master-slave and sound activated or auto operation Control Channel: 16/18 DMX Channels USITT DMX-512 • Power Consumption: 250w Dimensions: 270(D)*270(W)*470(H)mm • Packaging Size: 305(D)*305(W)*500(H)mm • Net Weight: 13.5kg TX5 Hybrid – GAMMA LED Vision Page 22 of 24... - Page 23 TX5 Hybrid – GAMMA LED Vision Page 23 of 24...
- Page 24 Photometric Data TX5 Hybrid – GAMMA LED Vision Page 24 of 24...