Everbilt 1005129161 Use And Care Manual page 13

Installation (continued)
3.
Removing the water tank
A. Use a screwdriver or open-end wrench to loosen the connection bolts between the water tank and
bowl, and remove the connection bolts.
B. Remove the water tank and pl ace it in the prepared flat position.
C. Remove the rubber gasket. Unscrew the lock nut and the flush valve.
1
4.
Preparing the flush valve
A. Rotate the valve body (A1) and remove it from the base (A2).
B. Loosen the lock nut (A3) and remove it from the base (A2).
C. Rotate the adjustable overflow pipe (A4) to unlock it. Adjust the overflow port height (OL) up and
down, measure the distance from the base seal to the overflow pipe rim, and ensure that the overflow
height is consistent or close to 2A measurement data. Afterwards, rotate the adjustable overflow pipe
(A4) to lock it.
NOTE: The adjusted overflow height OL should be lower than critical water level CL, and the distance must be greater than
or equal to 25mm.
1
A1
2
3
Water
Tank
Bolt
Rubber Gasket
Bowl
3
Overflow cap
A2
A3
Locknut
Locked Unlock
A4
7
Please contact 1-800-305-1726 for further assistance.
HOMEDEPOT.COM