Cub Cadet Ultima ZT Series Operator's Manual page 15

F. BRAKE PEDAL
The brake pedal is located in the center of the tractor, in front
of the floor pan. The brake pedal can be used for stopping the
tractor or setting the parking brake.
Setting The Parking Brake
1. Push the brake pedal (a) all the way forward and to the
right (Figure 18).
2. Rotate the brake pedal pad (b) forward to engage the
parking brake latch (c).
3. Ensure the brake pedal is fully engaged with the parking
brake latch.
4. To disengage the parking brake, push the brake pedal
forward and rotate the pedal back.
NOTE: The brake pedal must be fully depressed to start the
tractor. Refer to Safety Interlock Switches for more information.
a
Figure 18
G. USB CHARGING PORTS (IF EQUIPPED)
If equipped, a pair of USB power sources are
located to the right of the operator's seat. The
two USB ports are both rated 2.1A. The ports
can be used to charge your phone or power up
other USB devices.
H. CUP HOLDER
The cup holder is located to the right of the operator's seat.
I. STORAGE TRAY
The storage tray is located to the right of the operator's seat.
J. CHARGING PORT
The charging port is located to the left of the operator's seat. To
access the charging port, lift up on the charging port cover.
Do not have any devices plugged into your USB charging
port when starting the tractor. Doing so may cause
damage to your device.
OPERATION
b
WARNING
K. SEAT ADJUSTMENT LEVER (NOT SHOWN/IF EQUIPPED)
The seat adjustment lever is located under the seat. The seat
adjustment lever allows for adjustment forward or backward of
the operator's seat. Refer to the Assembly & Set-Up section for
instructions on adjusting the seat position.
Note: If your tractor is not equipped with a seat adjustment
lever, it can be adjusted using the knobs on the underside of the
seat. Refer to the Assembly & Set-Up section for instruction on
adjusting the seat.
Operation
Safety Interlock System
Do not operate the tractor if the safety interlock system
is malfunctioning. This system was designed for your
safety and protection.
This tractor is equipped with a safety interlock system for the
protection of the operator. If the interlock system should ever
malfunction, do not operate the tractor. Contact an authorized
service dealer.
• The safety interlock system prevents the operator from
c
turning the tractor ON unless the operator is in the seat
with the lapbar drive control levers fully out and in the park
position.
• The tractor will not operate with the charger cord plugged
into the charging port and/or the charging port cover open
or removed.
• The tractor will automatically shut off the blade(s) and drive
motors if the operator leaves the seat.
CHECKING THE SAFETY INTERLOCK CIRCUITS
• With the tractor running, move both lapbar drive control
levers fully inward in the neutral position. Lift upward from
the operator's seat; the tractor should stop.
• With both lapbar drive control levers fully outward and the
parking brake engaged, press the PTO button to engage the
blades. Lift upward from the operator's seat; the tractor
should stop.
15
WARNING