Operation - Camp 4 MARY User Instruction

UK
NOTICE:
The parts maybe different for different clients, check with the
dealer first to make sure that you understand the parts clearly.
INSTUCTION FOR ASSEMBLING AND INSTALLING
The following steps must be carried out in well ventilated places for from flames
or flammable materials.
- The cooker must be connected to the cylinder using a rubber hose for
LPG in comformity with the regulations of the country in which the cooker is to be used.
- The hose must be no longer than 1.5m and should be replaced in
compliance with current legislation in the country use when its time has run out
- Always use a low-pressure regulator to connect the cooker to the
cylinder. This regulator MUST be with normalised fixed calibration
at 30 mbar for butane and 37 mbar for propane.
- Metal hose clips suitable for gas must be used to secure the hose to the
cooker and to the regulator in the countries where it is allowed to fix
the hose to the actual appliance.
CAUTION
- Never use flames to check for gas leaks. Always use soap water.
- Never operate the appliance if the rubber hose is not firmly secured the recommended clips.
- Do not use the appliance should there be leaks, damage or malfunction.
- Avoid the lid falling down accidentally from their raised position.

OPERATION

- Place the cooker on a firm, level surface
- Locate the cooker far from flammable liquids and in any case far from objects
that are affected by heat.
- Check that cooker taps are closed.
- Check that the burner spring clips in the part underneath the burner
are firmly positioned and cannot be removed.
- If the model has a lid, open the lid gently.
- Fully open the gas cylinder tap.
- Press the cooker tap corresponding to the burner to be lit and turn it counter-clockwise
to the maximum setting.
- This model has no piezo: put a flame to the burner to be lit.
- Adjust the flame as required.
- Do not move the cooker with the burner lit
10