Step 7. Check The Ignition Of Cooktop Burners; Step 8. Checking The Flame Quality - Samsung NA24T4230FS Installation Manual

Step 7. Check the ignition of cooktop burners

Check the operation of all cooktop burners after the cooktop has been installed
and assembled, gas supply lines have been carefully checked for leaks, and
electrical power cord has been plugged in.
2
1
NOTE
• If the burner does not light within 4 seconds, turn the knob off and wait one
minute before trying again.
• When you push in and turn the control knob, all spark igniters will make a series
of sparks, but only the burner turned to Lite will light.
• If the igniters are dirty, this makes the burner harder to light, so you should
keep them as clean as possible. Do this with a small brush and make sure that
the ignition device is not hit or knocked violently.
• The flame supervision device shall not be operated for more than 15 seconds. If
after 15 seconds the burner has not lit, stop operating the device and open the
compartment door and /or wait at least one minute before attempting to
reignite the burner.
To turn on a cooktop burner
1. Fully press down the control knob for
the corresponding cooking position and
turn it to the left, to the Lite position,
and hold it here for a few seconds at
most until the burner ignites.
After igniting, keep the control knob
2.
pressed for about 5-8 seconds more
because the heat sensor that opens the
gas channel has to warm up first. Set
control knob to the position you want.
Repeat steps 1 and 2 to check the
3.
operation of each cooktop burner in
succession.
The flame size can be set continuously
4.
between maximum and minimum by
slowing turning the control knob.
flame supervision device
When you light the hob, the safety device
1.
starts to operate.
Because of the existence of gas safety
2.
devices, the hob can work normally.
When the flame of the hob is suddenly extinguished, the safety device will cut
3.
off the gas supply system of the hob within 60 seconds to ensure that the gas
does not leak.
4. After the flame is extinguished, turn the knob to the OFF position, and then re-
ignite the hob to resume normal operation;
5. When the knob is turned to the LO position, if the flame is relatively small and
the safety device cannot be burned, the hob will suddenly go out. At this time,
you need to adjust the small fire adjustment device clockwise according to the
method on page 25, and then reignite the hob, it can work normally.

Step 8. Checking the flame quality

All combustion flames need to be visually checked to determine their flame
quality.
CAUTION
If you attempt to measure the flame, please use caution. Burns could result.
1
2
3
1. Soft blue flames—Normal for natural gas
operation.
2. Yellow tips on outer cones—Normal for
LP gas operation.
3. Yellow flames—Abnormal for any gas
operation; call for service.
NOTE
If burner flame looks like 3, the cooktop
should not be used until it is serviced. Call
for service. Normal burner flames shall look
like 1 or 2, depending on the gas type you
use.
English 19