Technical Specifications - unotec PITALY II Manual

• After a few seconds the Bluetooth devices found will appear. Select
"LC-8200" and follow the instructions on the screen him out.
• If you ask for a password or PIN, enter 0000.
• If everything went correctly you can now use the Bluetooth stereo
headset with your phone normally.
C. Charge
The device is charged via microUSB port built with a standard cable.
The initial charge should be 6 hours. While in charging the red LED
will be on. At the end of it, it will turn off.
Note: You must load the device if it has not been used in the past nine
months.
D. Language change:
with the device switched off, press and hold the
Play / Pause button for 6 seconds. The LED flashes blue / red. Now
press twice on the Play / Pause button, the user language will change
from Chinese to English and vice versa (you will hear a sound indicat-
ing the language change)

Technical specificaTions

Bluetooth specification: 3.0 + EDR.
Supports A2DP 1.2, AVRCP 1.0, HFP 1.5, HSP 1.0. Bluetooth Profile
Operating range: 10 meters (varies depending on the environment).
Frequency Response: 80Hz - 20 kHz.
Speaker output: 10mW.
Signal / noise ratio:> = 80dB.
Distortion: <= 5.0%.
Play time: 8 hours.
Charging time: 2.5 hours.
Dimensions: 156.9 x 163.5 x 42 mm.
Weight: 120g.
The manufacturer assumes no responsibility for any errors or omissions
in this document. Some features may vary from the printing of this
manual.
4 english