Alfa Romeo Giulia-GTA Owner's Handbook Manual page 41

INSTRUMENT PANEL AND CONTROL
BUTTON GRAPHIC BRIGHTNESS
ADJUSTMENT
With side lights or headlights on, move
the ring (3)fig. 47 upwards to increase
light brightness of the instrument panel
and of the control button graphics, or
ring downwards to decrease it.
The control is pulsed so that for
every action the level intensity
increases/decreases, up to a maximum
of seven.
47
SBL (Static Bending Light) FUNCTION
(where provided)
The SBL LEDs activate to light the road
better and increase the light angle during
cornering.
This function is enabled by rotating the
light switch to the or AUTO position.
The SBL LEDs activate if the steering
radius is below 500 m (or equivalent
value in miles).
HEADLIGHT ALIGNMENT ADJUSTMENT
Light beam direction
The correct aiming of the headlights is
important for the comfort and safety
of not only the driver but all other road
users. This is also covered by a specific
rule of the highway code.
The headlights must be correctly
aligned to guarantee the best visibility
conditions for all drivers while travelling
with headlights on.
Contact a Dedicated Alfa Romeo
Dealership to have the headlights
checked and adjusted, if necessary.
ADJUSTING THE HEADLIGHTS WHEN
ABROAD
Dipped beam headlights are adjusted for
driving in the country where the vehicle
was originally purchased.
When travelling in countries with
opposite driving direction, to avoid
04126S0017EM dazzling the drivers on the other side of
the road, you need to cover areas of the
headlight according to the Highway Code
of the country you are travelling in.
WARNING
17) The daytime running lights are an
alternative to the dipped headlights while
driving during the daytime in countries
where it is compulsory to have lights on
during the day; where it is not compulsory,
the use of daytime running lights is
permitted.
18) Daytime running lights cannot replace
dipped beam headlights while driving at
night or through tunnels. The use of daytime
running lights is governed by the highway
code of the country in which you are driving.
Comply with legal requirements.
INTERIOR LIGHTS
FRONT CEILING LIGHT
There are switches on the ceiling light
that perform the following functions:
switch (1) turns light (8) on/off;
switch (2) activates/deactivates the
rear ceiling light buttons;
switch (3) turns all lights inside the
ceiling lights (front and rear) in the
passenger compartment on/off;
switch (4) activates or deactivates
turning ceiling lights (6), (7) and (8) on/off
when the doors are opened/closed. The
lights switch on/off gradually;
switch (5) turns light (6) on/off.
39