Dirt Devil M0914 Instruction Manual page 2

1. Retractable Bristles
6. Charging Light
2. Dirt Cup
7. Dirt Cup Release Button
3. ChargingIStorage Base 8. Crevice Tool Release Button
4. Handle 9. Crevice Tool
5. OnIOff Switch
A. CHARGING/STORAGE BASE
Designed to sit in the charging base on a flat surface (Diagram 1) or mount
vertically (Diagram 2).
For tidy storage, wrap excess cord on the back of the charging base and exit
at either side or out the bottom.
TO WALL MOUNT:
1. Place charging base against the mounting surface. Mark the centers of the holes.
2. Move base, then drill a 3/16" hole through the center of the marks.
3. Push plastic wall anchor into the drilled hole.
4. Be sure marked location is correct before drilling the second hole (adiust if
.
.
necessary). Drill second hole and install other wall anchor.
I
Sits on a flat surface.
5. Match up holes in storaae base to wall anchors and insert screws. Be sure
cord exits from one of the cord slots on the storage base.
6. Tighten the screws to hold the base flush to the mounting surface.
B. UNlT STORAGE
1. Hold the unit by the handle and push down firmly onto the charging base.
2. Be sure the red charging light is on.
C. CHARGING
NOTE: Use only the charger supplied by the manufacturer to recharge.
IMPORTANI: BEFORE FIRST USE, CHARGE YOUR UNlT FOR AT LEAST 24 HOURS.
Power switch must be in the OFF position.
Keep the charger plugged into a standard outlet at all times. It is normal for
the charger to become warm to the touch when charging.
If the operating time gets shorter after repeated use, let the unit run until it
Can easily be mounted on
stops running. Recharge for 24 hours and repeat monthly for best results.
wall.
TO USE: Slide the Dower switch to the ON nosition.
TO TURN UNlT OFF: Slide the power switch to the OFF position.
Empty and clean the unit and filter after each use or after large pickups when the unit
becomes full.
The crevice tool is permanently stored on-board. It is located on the top of the dust
CUD
for vour convenience.
. .
TO USE TO STORE
Press the crevice tool Flip crevice tool down
TO store crevice tool:
Ideal for cleaning delicate
release button. to line up with nozzle Pull down until loose.
surfaces. To use: slide the
then press up until Flip crevice tool up switch underneath dirt con-
secure in place. towards unit and you
tainer forward. Slide switch
feel it lock into place.
back to retract bristles.
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG VACUUM BEFORE SERVICING
OR CHANGING FILTER.
and debris out of
ket to remove
Depress the dirt cup release Hold nozzle over a wastebas-
button and pull nozzle away ket. Grasp filter and gently
from unit. pull out.