Nevir NVR-4371 C Instructions For Use Manual page 23

Door Swing Reversal
Reversing the door swing
The refrigerator has the capability of
opening the door from either the left or the
right side.
The unit is delivered to you with the door
opening from the left side.
To change the opening direction, please
follow these instructions.
Note: Before reversing the door swing,
unplug the appliance from the mains or
disconnect the electrical power supply.
1. Remove the two screws (3) holding the
top hinge (4) (right side) to the frame.
Remove the top hinge (4).
2. Lift the door off the middle hinge pin and
place it on a no scratching surface.
3. Remove the two screws (5) holding the
middle hinge (6).
Remove the middle hinge (6).
4. Lift the lower door off the bottom hinge
pin and place it on a no scratching surface.
5. Remove the two screws (7) holding the
bottom hinge (8).
Remove the bottom hinge (8).
6. Remove the left front leg (9) and transfer it
to the right side.
7. Before replacing the bottom hinge (8),
remove the hinge pin (10) and reverse the
direction of the hinge (8). Reassemble the
bottom hinge (6) on the left hand side using
the two screws (7).
8. Refit the hinge pin (10) into the bottom
hinge (8).
9. Lower the door onto the bottom hinge pin
(10).
10. While holding the lower door in the
closed position, reassemble the middle
hinge (6) on the left hand side using the two
screws (5). Do not tighten the screws (5) until
the top of the lower door is level with the
counter top.
11. Before replacing the upper hinge (4),
remove the hinge pin (2) from right hole to
left hole of the upper hinge (4).
12. Lower the upper door onto the middle
hinge pin.
13. While holding the upper door in the
closed position, reassemble the upper hinge
(4) on the left hand side using the two screws
(3). Do not tighten the screws (3) until the
top of the upper door is level with the
counter top.
Note:
The direction of door opening can be
changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
23