Advanced New Message Alerting Features - Panasonic KX-TGH222C Operating Instructions Manual

Answering System
Key Operation
MDN or MCN Adjust the receiver/speaker
volume (during playback)
1 or MFN Repeat message (during
playback)
2 or MEN Skip message (during
playback)
3 Enter the "Settings" menu
4 Play new messages
5 Play all messages
6 Play greeting message
76 Record greeting message
8 Turn answering system on
MPAUSEN
Pause message
9 or Stop recording
MSTOPN Stop playback
0 Turn answering system off
*4 Erase currently playing
*4
message
*5 Erase all messages
*6 Reset to a pre-recorded
greeting message
*1 If pressed within the first 5 seconds of a
message, the previous message is
played except when playing back from
the message list.
*2 When you play a message from the
message list, the unit stops message
playback and the display goes back to the
message list.
*3 To resume playback:
MbN: "Playback" a MSELECTN
*4 You can also erase as follows:
MPAUSEN a MbN: "Erase" a
MSELECTN a MbN: "Yes" a MSELECTN
Calling back (Call Display
subscribers only)
1
Press MPAUSEN during playback.
2
MbN: "Call back" a MSELECTN
n Editing the number before calling back
1
Press MPAUSEN during playback.
38
TGH21xC(en)_0715_ver110.pdf
*1
Erasing all messages
*2
1
2
Advanced new message
alerting features
Audible message alert
*3
This feature allows the base unit to beep to
inform you of a new message arrival when
new messages are recorded. The base unit
beeps 2 times every minute until you listen to
the messages, if the "Base unit beep"
setting is turned on. The default setting is
"Off".
1
2
New message alert by a call
This feature allows you to receive a
notification by phone when new messages are
recorded. The base unit calls a phone number
you specify. You can then operate the
answering system remotely to listen to the
new message.
To use this feature, you must:
– store a phone number to which the unit
– turn on the new message alert setting.
After you answer the new message alert call,
you can listen to messages from that call
(page 39).
Important:
R A new message alert is stopped 1 minute
38
2
MbN: "Edit" a MSELECTN
3
Press MEDITN repeatedly until the
phone number is shown in the desired
format (page 35). a M
MMENUN (right soft key) #325
MbN: "Yes" a MSELECTN a MOFFN
MMENUN (right soft key) #339
MbN: Select the desired setting. a
MSAVEN a MOFFN
makes the call to.
after the unit starts to call. The unit will not
retry the call even if the call is not answered.
N
2014/07/15 15:51:30