MED Associates NOLDUS SG-233 User Manual

MED Associates NOLDUS SG-233 User Manual

I/o interface

Advertisement

instrumentation and software for research
NOLDUS I/O INTERFACE
SG-233
USER'S MANUAL
-238
DOC
Rev. 1.1
Copyright ©2014
All Rights Reserved
Med Associates Inc.
P.O. Box 319
St. Albans, Vermont 05478
Phone: 802.527.2343
Fax: 802.527.5095
www.med-associates.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NOLDUS SG-233 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for MED Associates NOLDUS SG-233

  • Page 1 NOLDUS I/O INTERFACE SG-233 USER’S MANUAL -238 Rev. 1.1 Copyright ©2014 All Rights Reserved Med Associates Inc. P.O. Box 319 St. Albans, Vermont 05478 Phone: 802.527.2343 Fax: 802.527.5095 www.med-associates.com...
  • Page 2 Chapter 2 | Wiring Instructions ................. 2 Powering Other Devices Using the SG-233 ............3 Chapter 3 | Changing the Output Configuration ............4 Appendix A | Contact Information ................5 - i - DOC-238 Rev 1.1 Copyright © 2014 Med Associates, Inc.
  • Page 3 M E D A S S O C I A T E S , I N C . S G - 2 3 3 I / O I N T E R F A C E - ii - DOC-238 Rev 1.1 Copyright © 2014 Med Associates, Inc.
  • Page 4 Standard 28V outputs and two Med Associates Standard 28V inputs, which are linked to a Noldus standard RJ-45 connection. The SG-233 may be powered by a Med Associates power supply (e.g. SG-501) via a two- pin 28V Molex connection, or a 28V DC power supply (e.g. SG-508). A two-pin Molex 28V output is also included to provide power to additional SG-233 or any other Med Associates device using a daisy chain configuration.
  • Page 5 SG-233 to a standard wall outlet. b. Using an SG-210CP 2-pin Molex cable, connect the 28V IN 2-pin Molex connector on the SG-233 to a Med Associates Power Supply (e.g. SG-501). 4. Control the SG-233’s outputs or monitor its inputs using Noldus’ Ethovision XT software.
  • Page 6 S G - 2 3 3 I / O I N T E R F A C E Powering Other Devices Using the SG -233 Additional Med Associates devices can be powered using the 28V OUT connector on the SG-233, including multiple SG-233 interfaces.
  • Page 7 S G - 2 3 3 I / O I N T E R F A C E CHAPTER 3 | CHANGING THE OUTPUT CONFIGURATION Most Med Associates equipment will activate when a “low” signal is received from an output such as those on the SG-233. The outputs on the SG-233 can operate in one of two ways, Normal or Invert mode.
  • Page 8 7. When done, replace top cover and secure the screws. APPENDIX A | CONTACT INFORMATION Please contact Med Associates, Inc. for information regarding any of ou r products. Visit our website at www.med-associates.com for contact information. For technical questions, email support@med-associates.com.

Table of Contents