Electrolux EW8F169SA User Manual page 21

'AutoDose configuration mode' how to
change the basic setting, but before:
1. Identify the water hardness level.
Check the water hardness level in
your area. The levels are generally
indicated as: soft, medium and hard.
If necessary, please contact your
local water authority to check the
water hardness in your area.
2. Identify the customized detergent
dosage.
Check the label in the detergent/
fabric softener container suggesting
the quantity to use. This suggestion
is measured combining three
different factors:
• Water hardness level;
• Normal soil level;
• Rated capacity of the appliance
(e.g. maximum load capacity 9
kg). If the rated capacity on the
product container refers to lower
capacity appliances, the
customized dosage should be
increased.
7.4 AutoDose configuration
mode
Enter the AutoDose
configuration mode before
proceeding with any
programme setting. The
configuration mode may
cancel temporary settings .
1. Press the On/Off button for a few
seconds to activate the appliance.
2. Wait about 10 seconds for appliance
internal check.
3. To enter in configuration mode, hold
pressed the Temperature
Spin buttons simultaneously for a
few seconds until the display shows
the on the left in the display
and blinking detergent tank
softener tank
right in the display.
and the
and
indicators on the
4. Touch related tank buttons to toggle
function off and on. The display
shows OFF when a tank is disabled
or shows tank indicator when it is
enabled.
5. To set basic dosage touch related
tank buttons until default dosage
laundry product and two arrows on
bottom of display appear. Touch the
Temperature
adjust the dosage upwards and the
Spin button to adjusts it
downwards. Minimum step is 1 ml.
6. After about 10 seconds the display
returns to the programme information
screen or hold pressed the
Temperature
buttons again to exit immediately.
ENGLISH 21
button repeatedly to
and the Spin