Table of Contents
Related Manuals for Johnson & Starley Q-VENT COMPACT-R
Summary of Contents for Johnson & Starley Q-VENT COMPACT-R
- Page 1 Publication No. ZZ 1586-3 April 2016 Q-VENT COMPACT-R High Efficiency Ventilation System with Heat Recovery INSTALLATION, COMMISSIONING & SERVICING INSTRUCTIONS These instructions are to be left with the user www.johnsonandstarley.co.uk...
-
Page 2: Table Of Contents
CONTENTS Features General Description Carton Content Building Standards & Regulations Safety, Electrical & Water Information ErP Fiche Technical Data Preparation & Positioning Ducting Information Positioning The Unit Spigots Condensate Typical Room Layout Duct & Duct Connections Installation Instructions 10 Electrical 11 Fan Performance Graph 12 Circuit Diagrams 13 Commissioning... -
Page 3: Features
Q-VENT COMPACT-R main internal features GENERAL DESCRIPTION The Q-Vent Compact-R System provides mechanical ventilation to the living/bedroom. The unit is designed to provide continuous low level extraction from the wet rooms via a system of fixed ductwork and grilles. Heat is recovered from the stale contaminated air drawn from the wet room and uses a high performance heat exchanger recovering the heat and transferring it to temper the incoming fresh air into the living/bedroom. -
Page 4: Carton Content
PCB & RTC PCB FEATURES RV1 Speed Adjuster RV2 Speed Adjuster Installer Mode Switch LED Light Real Time Clock Test Switch Main PCB RTC PCB FIGURE 2. Q-VENT COMPACT-R with a cut out section showing the fans & PCB www.johnsonandstarley.co.uk... -
Page 5: Building Standards & Regulations
BUILDING STANDARD & REGULATIONS BUILDING STANDARDS & INSTALLATION REGULATIONS • Building Standards (Scotland Consolidation) Building Regulations • Part F of the Building Regulations • BS 5720 Mechanical Ventilation and Air Conditioning in Buildings • BS 7671 Requirements for Electrical Installations. Wiring Regulations •... -
Page 6: Erp Fiche Technical Data
TECHNICAL DATA EU Regulations No. 1233/2014, Implementing Directive 2009/123/EC & supplementing Directive 2010/30/EU. TABLE 2. ErP TECHNICAL FICHE Q-VENT COMPACT - R PRODUCT DATA SYMBOL VALUE Declared Typology Bidirectional Type of Drive Installed Three-Speed Type of Heat Recovery System Recuperative Thermal Efficiency of Heat Recovery 87.7 Maximum Flow Rate... -
Page 7: Preparation & Positioning
7.1.2 Ducting passing through unheated roof voids must be insulated. Ducting runs should be as straight as possible and the horizontal exhaust ducting should always slope downwards from the Q-Vent Compact-R unit. 7.1.3 The recommended types of ducting are:- rigid plastic and spiral wound duct. -
Page 8: Typical Room Layout
NOTE: The Q-Vent Compact-R unit is pre-configured for drainage. RIGHT HAND DRAIN OUTLET... -
Page 9: Duct & Duct Connections
DUCT & DUCT CONNECTIONS (Refer to design drawing) Four 100mm/125mm nominal diameter spigots for connection of the ducting (see diagram for positioning of the spigots Figure 1). These must be connected to the supply and exhaust duct. NOTE: Where rigid ducting is used it must fit outside the 1235mm spigots for 125mm ducting and on the inside of the 100mm spigots for 100mm ducting. -
Page 10: Installation Instructions
A facility is included which boosts the duty as required. The boost is achieved by:- Connecting C I R C U I T black wire (from the mains lead) to boost switch i.e. bathroom light switch. FAN PERFORMANCE GRAPH FIGURE 9. Q-VENT COMPACT-R TRICKLE AND BOOST CURVES www.johnsonandstarley.co.uk... -
Page 11: Circuit Diagrams
CIRCUIT DIAGRAMS COLOUR CODE BROWN BLUE BLACK GNYE GREEN/YELLOW WHITE YELLOW FIGURE 10. Q-VENT COMPACT-R WIRING DIAGRAMS FIGURE 11. JS9 SWITCH WIRING DIAGRAM Sales/Replacement Telephone 01604 762881... -
Page 12: Commissioning
COMMISSIONING 13.1 PRE COMMISSIONING CHECK Before commencing the commissioning procedure, refer to the design drawing for correct air flows. See Figure 5. NOTE: Extract air and supply air volumes will not always be equal, therefore, when setting up, the extract system should be the datum. -
Page 13: Water Detection In Condensate Tray
NOTE: In manual modes 1 & 2, if the switch live is turned ON, POSITION 1 POSITION 2 both fans turn to the setting which was set in the auto mode. FIGURE 12. POTENTIOMETERS ON REVERSE OF SWITCH COVER TABLE 4 AUTO BY-PASS SWITCH POSITION... - Page 14 DIP SWITCH (Factory Set) TABLE 5 DO NOT ALTER THESE SETTINGS FAN 1 EXTRACT FAN ADJUSTER FAN 2 SUPPLY AIR FAN ADJUSTER RED LED INSTALLER FLASHING MODE LIGHT SWITCH RTC TEST DIP SWITCH SWITCH DIP SWITCH POSITIONS 1 2 3 4 FIGURE 13.
-
Page 15: Servicing & Maintenance
SERVICING & MAINTENANCE IMPORTANT: Before commencing any servicing or component replacement. Ensure the ELECTRICAL SUPPLY to the unit is ISOLATED. NOTE: This unit is suspended and care MUST be taken when removing the access panel. Take care no components fall out. 14.1 All filters must be cleaned first before commencing servicing and maintenance. -
Page 16: Servicing Carried Out With Fans In Place
14.5 HEAT EXCHANGER, CONDENSE TRAY REMOVAL AND SERVICING 14.5.1 Disconnect the flexible pipe from the condense adapter, be aware the condense pipe may contain water. 14.5.2 Withdraw the heat exchanger and condense tray assembly by pulling on the securing strap and remove from the unit. -
Page 17: Real Time Clock (Rtc) Battery Checks
NOTE: Do not break open the fan case assembly as this will void the warranty. 14.7.3 Replace fan assembly and refit in reverse order. 14.8 REAL TIME CLOCK (RTC) BATTERY CHECKS 14.8.1 The battery needs to be checked at regular intervals to make sure there is always a back up power in case of a mains power loss. -
Page 18: Dimensions
DIMENSIONS FIGURE 21. Q-VENT COMPACT-R DIMENSIONS www.johnsonandstarley.co.uk... -
Page 19: Exploded Diagram
EXPLODED DIAGRAM FIGURE 22. Q-VENT COMPACT-R EXPLODED DIAGRAM SPARES LIST ITEM PART No. DESCRIPTION HR34-0119005 Air Circulation Fan Assembly (Complete) HR30-0119005 Heat Exchanger & Condense Tray Assembly (Complete) HR34-0120005 Front Cover Assembly 1000-0523605 Fan Control PCB Board 1000-0530355 Real Time Clock PCB Board... - Page 20 Johnson & Starley Ltd Rhosili Road, Brackmills, Northampton NN4 7LZ sales@johnsonandstarley.co.uk marketing@johnsonandstarley.co.uk Reception/Customer Service 01604 762881 01604 767408 Anniversary 1922 - 2012 In the interest of continuous development Johnson & Starley reserve the right to change specifications without prior notice.
Need help?
Do you have a question about the Q-VENT COMPACT-R and is the answer not in the manual?
Questions and answers