Table of Contents
Advertisement
MODELS: WD-52627 / 52628 / 62627 / 62628 / 62827 / 62927 / 73727 / 73827 / 73927
3. Adjustment Selection
Use the "VIDEO" button to select a specific electrical ajustment, "1 HPOS" or "2 VPOS".
4. Adjusting Data
After selecting an adjustment item, use the "UP" and "DN" buttons to change adjustment data.
ª If the "UP" button is pressed, the adjustment data increases.
ª If the "DN" button is pressed, the adjustment data decreases.
5. Saving data
Press "ENTER" to save the adjustment data in memory.
The display characters go red for approx. one second in this step.
Note: If the circuit adjustment mode is terminated without pressing
"ENTER", changes in adjustment data are not saved.
6. Terminating the circuit adjustment mode
Press the "MENU" button on the remote hand unit twice to terminate the adjustment mode.
Note: The adjustment mode can be also terminated by turning the
power off.
Resetting Data to Factory Values
1) Enter the Service Adjustment Mode ... Press "MENU-2-4-5-7"
2) Press "0" when in the Service Mode ... Four choices appear at the top of the screen.
Data Transfer
Copy Engine E2PROM to DM
Restore Backup
UPLOAD TERMINAL BOARD DATA
Download WB Alignment to FMT
3) User UP & DN keys to highlight the desired choice, the Press "ENTER"
All manuals and user guides at all-guides.com
Display
Description
Transfers Engine data to DM E2PROM
Restores data to factory values
DO NOT USE
Transfers Engine data to FMT
Page 45
MENU-2-4-5-7-0
Advertisement
Table of Contents
