Clock Setting - Hisense HCPC-H2M1C Installation Instructions Manual

3 Configuration of Modbus Adapter

3.1.2 Clock setting

Change clock method 1
You can spot check and set real time clock through key + digital tube. Press and hold SW6+SW7 key at the same time for
3s and enter setting mode, as shown in below Table 3.3, current spot checked time is 18:15:28s, 17
NO.
1
2
3
4
5
6
7
Table 3.3 Set real time clock with key
·Press Up (SW5) or Down (SW8) until it shows "cloc.".
·In "cloc." Menu, press Select key (SW7) and confirm to enter clock setting mode.
·After setting, please press Eject/Switch key (SW6) to exit.
·Press SW7 so that the number of clock becomes editable, flashing in 1Hz.
·In menu, press Select key (SW7) so that the default clock flashes and becomes
editable.
·Press Eject/Switch key (SW6) to switch flashing, change the editable area.
·Press Up (SW5) or Down (SW8) to change the clock number.
·As above.
·As above.
·As above.
·The clock will keep running, second will be increasing but cannot be set.
·As above.
·Finally press Select key (SW7) to confirm, after setting, press Eject/Switch key
(SW6) to exit.
·The display will disappear automatically if no further action in 30s.
- 25 -
th
Oct., 2015.