Table of Contents
Advertisement
Net-2000™ Voice Codec Unit
User's Manual
Rack Mount installation
When a rack mount kit is purchased with the Net-2000™- P25 VCU the assembly is installed at the
factory prior to shipping. If the rack mount, needs to be removed there are three flat head Philips
screws on each side that secures the rack mount plate to the Net-2000™- P25 VCU chassis as
shown below. To avoid scratching the sides of the Net-2000™- P25 VCU when removing the rack
plate push down on the front of the plate so that it slips out from underneath the unit. When re-
installing the rack mount slip it up from underneath and push it back to be flush with front face. Use
the same six screws to secure the rack mount back on the chassis.
Figure 3 Rack Mount Installation
DVSI Confidential Proprietary
Section 2 – Net-2000™ VCU Installation
Page 6
Advertisement
Table of Contents
Need help?
Do you have a question about the Net-2000-P25 and is the answer not in the manual?