Digital Spectrum MemoryFrame MF-8000 User Manual

Changing the frame on the
MemoryFrame 8000 & 8104
Before trying to place the frame on the unit please read
these instructions
Take a moment to examine the unit. On the left side you will see
two fixed tabs, these are what will hold the frame in place. On the
right side you will see one spring tab. This is what is used to
remove and replace the frames.
The spring tab is
operated by pulling
back on the spring
lever on the back of
the unit. This allows
Spring tab
the spring tab to
retract before
Fixed tabs
positioning the
frame.
Spring lever
Fitting the frame
With the spring tab retracted lower the frame onto the unit
Positioning the frame
When fitting the frame make sure the two fixed tabs are positioned
to slide into the grove on the wooden picture frame.
Groove
Fixed tabs
Position the frames groove over the fixed lugs
1
Placing the frame
Make sure the frame fits snuggly before releasing the spring lever.
This will allow the spring tab to fit into the groove on the frame.
Spring lever
5
Make sure the tabs fit the groove
Spring tab
Make sure the groove sits tightly over the lugs
2
Fitting the frame snugly
The frame should then fit snugly to the unit
6
Operating the spring lever
To complete placing the wooden frame onto the unit, pull back
on the spring lever as shown below. This allows the spring tab
to retract.
3
Removing the frame
Removal and replacement is easy, just pull back on the spring
lever to release the frame.
7
4
8