Replacing The Fuse - Yamaha YW50A Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
IES OUT OF THE REACH OF
CHILDREN.
To charge the battery
1
Have a Yamaha dealer charge the
battery as soon as possible if it seems
to have discharged. Keep in mind that
2
the battery tends to discharge more
quickly if the vehicle is equipped with
3
optional electrical accessories.
4
NOTICE
To charge a VRLA (Valve Regu-
5
lated Lead Acid) battery, a special
(constant-voltage) battery charger
6
is required. Using a conventional
battery charger will damage the
battery.
7
To store the battery
8
1. If the vehicle will not be used for
more than one month, remove
the battery, fully charge it, and
9
then place it in a cool, dry place.
NOTICE: When removing the
b a t t e r y , b e s u r e t h e k e y i s
turned to "OFF", then discon-
nect the negative lead before
disconnecting the positive
lead.
[ECA16302]
2. If the battery will be stored for
more than two months, check it
at least once a month and fully
charge it if necessary.
3. Fully charge the battery before
installation. NOTICE: When in-
stalling the battery, be sure the
key is turned to "OFF", then
ECA16521
connect the positive lead be-
fore connecting the negative
lead.
[ECA16840]
4. After installation, make sure that
the battery leads are properly
connected to the battery termi-
nals.
NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
6-22

Replacing the fuse

1
ZAUM00**
1. Fuse
The fuse holder is located behind
panel A. (See page 6-8.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
ECA16530
2. Remove the blown fuse, and then
install a new fuse of the specifi ed
amperage. WARNING! Do not
use a fuse of a higher amper-
age rating than recommended
to avoid causing extensive
damage to the electrical sys-
tem and possibly a fi re.
EAU1722A
EAU23503
[EWA15131]