Summary of Contents for Baader Planetarium SUNDANCER II
Page 1
Manual and Application Tipps Thank you for your purchase of the Baader SunDancer II H-alpha filter! It is a high quality product for solar observation. When observing the sun, always exercise due caution and follow the safety instructions. For best results, we recommend that you spend a few minutes reading this manual before using the SunDancer II.
• The D-ERF energy rejection filter 1. SunDancer II H-alpha-filter unit comprising the blocking filter, 3x telecentric system is mounted in front of the telescope and focusing eyepiece holder # 2458125 and protects the filter system from 2.
You can also use D-ERF filters on smaller telescopes, as they protect the inside of the tube from the heat of the sun. This has no influence on the function of the SunDancer II, On all telescopes with more than 80 mm aperture as well as on telescopes with but it may affect the tube entrance and thus the possible maximum magnification.
The SunDancer II consists of two parts (plus the 1¼" eyepiece clamp). On the left is the actual H-alpha filter, i.e. the H-alpha filter and avoid to high magnifications. Exceeding etalon with the heating element and the micrometer screw.
The Celestron PowerTank Lithium LT 12V DC/ 4. Place the SunDancer II in the eyepiece clamp or the star diagonal (1¼" or 2") of USB 5V/ 73,3Wh (# 821038) has proven itself.
SunDancer II and then to a 12V power source. increasing the magnification; however, this presuppo- The electronics will then bring the filter up to operating...
To use a bino-viewer with T-2 connection, simply screw 1) Reducing-Ring 2"i / T-2a, with 1.5mm optical length the T-2 coupling nut onto the T-2 thread of the SunDancer II instead of the 1¼" eyepi- 2958244.
Calibrating the Filter and Calibrating the Filter The SunDancer II has been calibrated at the factory and should give the best image Settings of the Temperature Control Box when the micrometer screw has been turned clockwise as far as it will go without applying force and the heater has reached the preset target temperature, so that the temperature difference display is also at "0".
This is a problem of the camera and not of the filter; the fringe patterns rotate with you In total, you have three options for connecting a camera to the SunDancer II. For the when you turn the camera. In this case, it can...
Need help?
Do you have a question about the SUNDANCER II and is the answer not in the manual?
Questions and answers