Step 4: Connecting The Audio Cords - Sony RDR-GX310 Operating Instructions Manual

Step 4: Connecting the Audio Cords

Select one of the following patterns A or B, according to the input jack on your TV monitor, projector,
or AV amplifier (receiver). This will enable you to listen to sound.
A Connecting to audio L/R (left/right) input jacks
This connection will use your TV's or stereo amplifier's (receiver's) two speakers for sound. You can
enjoy the following surround effects (page 53).
• TV: Dynamic, Wide, Night
• Stereo amplifier (receiver): Standard, Night
B Connecting to a digital audio input jack
If your AV amplifier (receiver) has a Dolby
connection. You can enjoy Dolby Digital (5.1ch) and DTS (5.1ch) surround effects.
Optical digital cord (not supplied)
[Speakers]
Rear (L)
Front (L)
Center
: Signal flow
* The yellow plug is used for video signals (page 16).
18
(red)
(white)
(yellow)*
to LINE OUT (R-AUDIO-L)
R-AUDIO-L VIDEO
S VIDEO
3
LINE OUT
DIGITAL OUT
PCM/DTS/DOLBY DIGITAL S VIDEO
COAXIAL
R-AUDIO-L VIDEO
IN
OUT
OPTICAL
VHF/UHF LINE IN
to DIGITAL OUT (COAXIAL or OPTICAL)
DIGITAL OUT
PCM/DTS/DOLBY DIGITAL
COAXIAL
OPTICAL
to optical digital
input
AV amplifier (receiver)
with a decoder
*1 *2
Digital or DTS decoder and a digital input jack, use this
Audio/video cord
(supplied)
1 R-AUDIO-L VIDEO S VIDEO
3
COMPONENT
LINE OUT
VIDEO OUT
or
Coaxial digital cord (not supplied)
to coaxial digital
input
(yellow)
INPUT
VIDEO
(white)
L
(red)
AUDIO
R
TV, projector, or AV
amplifier (receiver)
DVD recorder
Y
P C
B/ B
P C
R/ R
~
AC IN
[Speakers]
Rear (R)
Front (R)
Subwoofer
A
B