Table of Contents
Advertisement
7
With the rear gate at the
desired height, press and
hold the Power Rear Gate
Close Button on the inside
edge of the rear gate. A chirp
will sound and the hazard
warning lights will flash to
confirm the height is set.
When "Power Rear Gate Memory" is enabled on in the Center Information Display (CID),
the rear gate will stop at the set memory height when you use any of the Power Rear Gate
switches.
NOTE: To adjust the memory height, perform the registering procedure again.
MEMORY DRIVER'S SEAT (if equipped)
You can set a seat position and retrieve it using the buttons on the driver's door or the
access key fob.
To set a seat position with a
button:
1. Make sure the select lever is in
the "P" position, with the
parking brake applied and the
ignition in the "ON" position.
2. Adjust the seat to the desired
position.
3. While holding the "SET"
button, press and hold either
button "1" or "2". A chirp
sounds when the position is
registered.
To retrieve the seat position set with a button:
1. Turn the ignition switch to "ON".
2. Put the select lever is in the "P" position and apply the parking brake. Then, press
button "1" or "2".
HOW TO APPENDIX
7
Memory Seat Buttons
129
Advertisement
Table of Contents
