Advertisement
INSTALLING THE MOUNTING ACCESSORY
The wall-mount bracket must be attached to a mounting surface such as hardwood, wall stud, concrete or
material capable of supporting the wall-mount and SiteWatch™ laser sensor. Installers may need to change
the mounting method or hardware used depending on the mounting surface material.
1.
Use the wall-mount bracket to mark and drill the necessary holes in the mounting surface.
2. Attach the wall mount bracket to the mounting surface using appropriate tapping screws (tapping
screws, plastic anchors and PTS1 M6x40L connector are not included).
1
3. Once the wall-mount bracket is secured, attach the SiteWatch™ laser sensor to the wall-mount using
the M5 screws included.
4. Once the SiteWatch™ laser sensor is secured to the wall-mount, adjust the position of the sensor
by loosening the tilt screw on the bottom of the wall-mount, using the hex key included. Adjust the
sensor's position vertically and horizontally. Once the required position is achieved, tighten the tilt
screw on the bottom of the wall-mount to complete the installation.
3
Quick Start Guide
2
4
Specifications and pricing are subject to change without notice.
Copyright © Digital Watchdog. All rights reserved.
Advertisement
