Advertisement
200A, 200S, 240, and 266T*L Series
Star
LED FIVE YEAR LIMITED WARRANTY
The manufacturer warrants this LED light against factory defects in material and workmanship for five years
after the date of purchase. The owner will be responsible for returning to the Service Center any defective
item(s) with the transportation costs prepaid. The manufacturer will, without charge, repair or replace at its
option, products, or part(s), which its inspection determines to be defective. Repaired or replacement
item(s) will be returned to the purchaser with transportation costs prepaid from the service point. A copy of
the purchaser's receipt must be returned with the defective item(s) in order to qualify for the warranty
coverage.
Exclusions from this warranty include, but are not limited to, domes, and/or the finish.
warranty shall not apply to any light, which has been altered, such that in the manufacturer's judgment, the
performance or reliability has been affected, or if any damage has resulted from abnormal use or service.
There are no warranties expressed or implied (including any warranty of merchantability or fitness), which
extend this warranty period. The loss of use of the product, loss of time, inconvenience, commercial loss or
consequential damages, including costs of any labor, are not covered. The manufacturer reserves the right
to change the design of the product without assuming any obligation to modify any product previously
manufactured.
This warranty gives you specific legal rights. You might also have additional rights that may vary from state to
state. Some states do not allow limitations on how long an implied warranty lasts. Some states do not allow
the exclusion or limitation of incidental or consequential damages. Therefore, the above limitation(s) or
exclusion(s) may not apply to you.
If you have any questions concerning this or any other product, please contact our
Customer Service Department at (585) 226-9787.
If a product must be returned for any reason, please contact our
Customer Service Department to obtain a Returned Materials Authorization
number (RMA #) before you ship the product back.
Please write the RMA # clearly on the package near the mailing label.
Beacons
featuring the
Hardwire Models : +12-24VDC
Cig Plug Models : +12VDC only
This
PLIT557 REV. B
4/19/18
Advertisement
Table of Contents
Related Manuals for Star Headlight & Lantern Star X FIRE 200A Series
Summary of Contents for Star Headlight & Lantern Star X FIRE 200A Series
- Page 1 200A, 200S, 240, and 266T*L Series Star Beacons featuring the Hardwire Models : +12-24VDC Cig Plug Models : +12VDC only LED FIVE YEAR LIMITED WARRANTY The manufacturer warrants this LED light against factory defects in material and workmanship for five years after the date of purchase.
- Page 2 200A Mounting 1. Remove the four screws in the side of the aluminum housing. 2. Slide the plastic base out of the aluminum case. Do not to damage the gasket. Remove the 4 screws in the side of the Aluminum housing and slide the plastic base out Gasket Plastic Mounting Base...
- Page 3 Pipe Mounting For NPT pipe, mount the light using the threaded entrance hole in the base of the light, then skip to the Wiring Instructions. 200S, 240, and 266 Surface Mounting 1. Decide which holes you will be using to mount your light. Models without a flange will have knockouts inside the base that can be used.
- Page 4 Wiring Instructions WHITE: Synchronization - AFTER setting the flash CAUTION: patterns, connect the white wires from All of our DC powered warning lights are synchronized lights together. Cap off if not used. polarity sensitive. These lights are RED: Power - Connect to +12-24VDC through polarity protected only if the appropriate your switch and a 5A fuse.
Need help?
Do you have a question about the Star X FIRE 200A Series and is the answer not in the manual?
Questions and answers