Centre Display, View Modes - Olsberg MultiDrive 3 Manual

Centre display, view modes

The centre display is the system's
information centre. It shows informa-
tion that is not directly related to the
crane's operation.
The symbols used for this information
are described in detail below.
The images to the right shows the
appearance of the centre display during
normal radio controlled operation of the
crane. LSS indicates that LSS mode has
been chosen. VSL+ indicates the extra
capacity that can be used thanks to load
on the vehicle. The stability diagram
shows eventual limitation of the lifting
capacity.
Fault
A symbol of a spanner is shown
when the safety system discovers a
fault in the system.
Micro
Indicates that micro operation has
been selected. Micro operation
changes the sensitivity of the levers
as follows: At full lever deflection,
μ50% yields 50% of normal speed
and µ20% yields 20% of normal
speed for the crane. The micro
values can be set at any value by
Hiab.
Service
Indicates that the crane requires
service.
Personnel basket or VSL+
Indicates that MEWP-mode
(operation from personnel basket)
has been selected. This requires
greater stability and lower speeds
for crane movement. VSL+
indicates how much extra lifting
capacity the crane has due to load
on the vehicle.
Signal strength
The number of bars shows the
signal strength. Optimum reception
is when all the bars are filled.
When the symbol flashes the radio
is connected but the start criteria
have not been met.
12 Technical description
Main menu
The text shows which main menu
has been selected while the num-
ber shows which sub-menu of
that main menu applies. The main
menus are:
CRANE, EXTRA and ON-OFF.
NOTE! The first menu number in
EXTRA is one higher than the
highest in CRANE. ON-OFF is
numbered from 1.
ADC (Automatic Duty Control)
Indicates that the ADC function is
on.
JDC (Jib Duty Control)
Indicates that the JDC function is
on.
If HDC or LSS mode is on it is
indicated in this position on the
display.
HDC (Hoist Duty Control)
LSS (Load Stability System)
Manual extension
Manual extension is selected by
pressing the horn and release but-
tons at the same time. The safety
system acknowledges by showing
this symbol.
Battery capacity
The battery symbol shows the bat-
tery power remaining. When the
system starts to blink there is only a
few minutes of operation left. Infor-
mation is sent to the safety system
which can then emit a warning
signal. If the system is run until the
battery power fails the hand con-
troller will automatically lock.