Advertisement
Quick Links
PL3 Camera Calibration
1、First, install the calibration software "SimpleBGC_GUI_2_40" on your Windows computer.
2、Loosen the two screws in the red box below and you can see the USB interface. Use the USB
cable to link the camera and the computer.
3、Place the camera on the horizontal table and press it flat with your hand.
4、Run the camera calibration software "SimpleBGC_GUI_2_40". And complete the calibration
according to the following steps:
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for SWELLPRO PL3
Summary of Contents for SWELLPRO PL3
- Page 1 PL3 Camera Calibration 1、First, install the calibration software "SimpleBGC_GUI_2_40" on your Windows computer. 2、Loosen the two screws in the red box below and you can see the USB interface. Use the USB cable to link the camera and the computer. 3、Place the camera on the horizontal table and press it flat with your hand. 4、Run the camera calibration software "SimpleBGC_GUI_2_40". And complete the calibration according to the following steps:...
- Page 2 Table 1: Click on the labeled red box, select COM66 or other maximum values, and click on the connection (Blue Arrow)
- Page 3 Table 2: After the connection is successful, the parameters on the right will change. The arrow indicates that the connection is successful. Click Load（red rectangle） Table 3: After loading, select firmware marked with red box and select Open...
- Page 4 Table 4: Select the writing of the red box, and the arrow in the lower left corner will show “从控 制器上成功载入参数”when the writing is successful. Table5:click the red box and the arrow in the lower left corner will show”加速度计校准开 始” ,and the arrow in the lower right corner will show a slight change. Note: If you can't see the value jump in the lower right corner, just wait 10 seconds for the next step.
- Page 5 Table 6: Select CALIB GYRO, the lower left corner will display the English letters, and the lower right corner arrow value will jump slightly. Note: If you can't see the value jump in the lower right corner, just wait 10 seconds for the next step.
- Page 6 Table 7: Choose Writing. The lower left corner of successful Writing will show”当前配置文件成 功写入控制器” Calibration is completed and pulled out USB cable . Check whether PL3 camera works properly by electrifying.
Need help?
Do you have a question about the PL3 and is the answer not in the manual?
Questions and answers