Table of Contents
Advertisement
2. INSTALLATION
2.1 UPON RECEIPT AND CLAIMS
●Be sure that you have received all the items that you
have ordered. In case of any items are missing or damaged,
contact your supplier immediately.
●Be sure that none of the following
the box.
2.2 WORK AREA
●Make sure that your line voltage is
Hz for
CT4973
is very good selection for welding
thickness metal. It is a very good choice for steel,stainless
steel MIG/MAG welding with 0.6-1.0mm welding wires.
CT4973
is very good selection for welding
●
thickness metal. It is a very good choice for steel,stainless
steel MMA welding with 1.6-4.0mm electrodes.
. And you have a neutral and earth line
work place.
●In order to cool down the machine and have
an efficient work, keep the machine at least 30
cm away from the surrounding objects. Do not
place any heat source, as oven, to front side of
the machine where the cooling air
Welding machine must not be effected of heat
directly.
Do not place the machine in small and
●
places. Beware of excessive dust and dirt.
Keep your machine away from wet and
●
places.
●Do not operate the machine under direct sunlight, rain
and wind. Machines should be operated on lower
capacities when ambient air temperature exceeds 40ºC.
Please use a suitable exhaust system for gases
●
2.3 INSTALLATION AND USAGE OF THE MACHINE
Only qualified persons should install,use or service this equipment. Protect yourself and others
from possible serious injury or death.
WARNING: Do not operate with covers removed.Disconnect input power before servicing.
Do not touch electrically live parts.
INSTALLATION
3
items are missing in
1 Phase , 230V, 50
1.2~6
mm
2.0~6
mm
present at your
is taken from.
narrow
humid
-9-
Welding Power Source
Earth Clamp/
Electrode holder
Cable
User Manual
●Transport and place the device on firm and
level ground so that it may not fall over. The
maximum permissible angle of inclination
for transport and assembly is 10°.
If the cylinder is placed on the machine
●
lock the chain to secure the tube, if not be
sure that gas cylinder is chained vertically to a
wall.
This machine is protected electronically
●
against overloading. Do not use stronger fuses
than those stated on the type plate of the
device.
●Ensure that the earth clamp has good and
direct contact near the welding location. Do
not direct welding current over chains, ball
bearings, steel cables, protection conductors
etc., Otherwise they may melt.
Ensure that operators can easily reach the
●
machine controls and equipment connections.
Use lifting eyes for lifting the machine.
●
Do
not lift the machine by using a fork-lift or
a similar vehicle.
The electrical socket behind machine is
●
only for heating CO
. Do not use it for any
2
other purpose.
and
Advertisement
Table of Contents
