Advertisement
And now . . . Replacing the Lamp
The PhotoFluor II and PhotoFluor II NIR 200 Watt lamps must be
properly installed to allow ignition, proper cooling and alignment to
assure the longevity of the bulb. Your unit is shipped with the lamp
installed. When removing the lamp, take care not to touch the
reflector surface (inside or outside) as finger oils or
contaminants will harm the bulb. The lamp's connector must be
properly installed.
After installing the bulb and the unit is turned on, you must reset the
lamp counter.
The bulb is pictured below:
Lamp Power Cable
Rev B
Figure 1: Lamp
The lamp should only be handled wearing gloves
and suitable eye protection.
Reflector
4
Advertisement
