Bosch GBH2-28L Operating/Safety Instructions Manual page 8

2610047986_GBH2-28L 10/2/17 1:47 PM Page 8
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
INSTALLING SDS-plus
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
FIG. 2
3
1
2
AUXILIARY HANDLE
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚. To
reposition and/or swivel the handle, loosen
the hand grip, move the handle to the
desired position along the barrel and
securely retighten the hand grip (Fig. 4).
DEPTH GAUGE
Your drilling depth can be pre-set and/or
repeated by using the depth gauge.
FIG. 4
1
Assembly
Disconnect the plug from
the power source before
®
ACCESSORIES
DUST
SHIELD
3
HAND
GRIP
2
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 2).
REMOVING SDS-plus
Accessories may be hot
after use. Avoid contact
with skin and use proper protective gloves or
cloth to remove.
To remove an accessory, pull locking sleeve
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 3).
LOCKING
SLEEVE
2
Setting depth: After the auxiliary handle is
installed, make sure the accessory has been
fully inserted into the tool holder before
setting the depth gauge (Fig. 5).
To adjust depth, push the depth gauge
release button, slide the depth gauge to
desired depth and release pressure on
button to lock the depth gauge in place.
DEPTH
GAUGE
FIG. 5
X
-8-
®
ACCESSORIES
1
FIG. 3
DEPTH
GAUGE
RELEASE
BUTTON