Table of Contents
Advertisement
Problem
The control panel brightness
is reduced or it switches off.
The control knob pilot lights
turn on after connecting the
hob to the mains or after a
power outage.
Hob²Hood function does not
work.
You cannot activate or oper‐
ate Hob²Hood and Minute
Minder.
The display shows "E t"
does not shows up when
knobs are opened.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or
Possible cause
The temperature of the plate
is high. To ensure long life‐
time of the display the bright‐
ness is reduced depending
on the temperature of the
hob. Above a certain tem‐
perature the control panel
switches off.
Pilot light test.
You covered the control pan‐
el.
There is water or fat stains
on the control panel.
-
Selected Automatic Mode is
A0.
dealer will not be free of charge, also
during the warranty period. The
instructions about the Service Centre
and conditions of guarantee are in the
guarantee booklet.
ENGLISH
Remedy
Let the hob cool down.
Refer to "Installation".
Remove the object from the
control panel.
Clean the control panel.
Turn off the control knobs
and wait until the display is
off or disconnect the appli‐
ance to the main to return to
the initial condition.
Refer to "Daily use".
23
Advertisement
Table of Contents
