Switching Off And Disconnecting The Appliance; Defrosting; Cleaning - Bosch B21CT80SNS Operating And Installation Instructions

Chiller Drawer
The Chiller Drawer has a maximum load of 22 lb
(10 kg).
Pulling out and installing the Chiller Drawer
1. Pull out the Chiller Drawer.
2. Find the hooks at the left and right sides at the
drawer bottom (shown in the figure).
3. Hold the hook at two sides with a nose pliers and
push it up and out of the groove of sliding rail and
take out the hook at the other side with the same
method.
4. Take out the drawer.
Hook
Sliding rail
5. Install the drawer by putting the hook into the slots.
Switching off and
disconnecting the appliance
Switching off the appliance
Unplug the appliance or switch off the fuse.
Disconnecting the appliance
If the appliance is not used for an extended period of
time:
1. It is imperative that you disconnect the water
supply to the appliance for a few hours before
switching off the appliance.
2. Remove all food from the appliance.
3. Unplug the appliance.
4. Empty and clean the ice maker and the ice storage
box.
5. Clean the appliance interior (see "Cleaning the
appliance").

Defrosting

Freezer compartment
The fully automatic Nofrost system ensures that the
freezer compartment remains free of ice. Defrosting is
not required.
Refrigerator compartment
Defrosting takes place automatically.
The condensation runs through the drainage hole into
an evaporation pan at the rear of the appliance.

Cleaning

Risk of electric shock!
Chiller Drawer
Unplug the appliance or turn off the circuit breaker
or fuse before cleaning the appliance.
To avoid personal injury or damage to property,
observe the following:
Never use a steam cleaner to clean the appliance.
Do not use abrasive or acidic cleaning agents or
solvents.
Wipe lights and the control and display panel with a
damp cloth only. Do not let water used for cleaning
drip into the lights or onto the control and display
panel.
Do not let cleaning water run into the drainage hole
in the evaporation area.
Never clean shelves and containers in a
dishwasher. The parts may warp.
For cleaning the Black Stainless Steel we advise
using a soft and dry towel. If the dirt on the surface
is not easy to clean/to remove only with a soft dry
towel, we advise to use warm water diluted with a
neutral cleansing agent.
Never use stainless steel cleaner.
Use only a non-abrasive, mild cleansing soap and
water solution for cleaning the Black Stainless
Steel.
WARNING
CAUTION
CAUTION
en-us
21