Bosch SHP88PW55N Operating Instructions Manual page 33

Press function key 3. Each time
6.
the button is pressed the set
value increases by one level;
when it reaches the value ›:‹„,
the display jumps back to ›:‹‹
(off).
Press Start button P to save
7.
the setting.
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete.
To save energy the recommended
setting is ˜:‹‚.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
To change the setting:
Open the door.
1.
Press On/Off button (.
2.
Hold down function key # and
3.
press Start button P until the
display 8 indicates •:‹x (x can
be any number).
Release both buttons.
4.
The indicator of function key #
flashes and the display 8
indicates the factory set value
•:‹...
Press function key # until the
5.
display 8 indicates ˜:‹x.
Press function key 3 until the
6.
display corresponds with your
requirements.
Press Start button P.
7.
Operating the Dishwasher en-us
Switching off the appliance
Short time after the end of the wash
cycle:
Open the door.
1.
Switch off On/Off button (.
2.
Turn off water supply.
3.
Remove the utensils when they
4.
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
33