Devolo MicroLink ADSL Modem User Manual page 19

'User Defined End Address': When working with a user-defined DHCP
address pool, enter the IP end address manually.
b
'DHCP Relay': If this function is enabled, the router will serve as a relay
and forward DHCP queries to the DHCP server.
'DHCP Relay Target IP': Enter the IP address of the DHCP server here
if the router is to be used as a relay.
The router can always perform only one function, i.e. either as a server or
relay.
Please note that disabling the DHCP server will disable the setup wizard. The
setup wizard can only be used if the MicroLink ADSL Modem Router is set
up as the DHCP server for the LAN.
WAN
Wide-area network settings can be defined under 'WAN'. The configuration
corresponds to your Internet access settings.
If you set up your Internet access using the setup wizard, and only plan to exe-
cute standard applications with the MicroLink ADSL Modem Router, the
entries on this screen do not need to be modified manually. Most of the fun-
ctions listed here, which are optimally and automatically configured by the
|
Router configuration
|
devolo MicroLink ADSL Modem Router
19
|