Related Manuals for diversey Taski balimat 2300
Summary of Contents for diversey Taski balimat 2300
- Page 1 balimat 2300 ___________________________________________________ Instruction Manual (Translation of the Original Version) 2021-04-28...
-
Page 3: Proper Use
English EN 1.4 EG K EC DECLARATION OF CONFORMITY CONTENTS ONFORMITÄTSERKLÄRUNG This operating manual contains instructions for using the sweeper. Carefully keep the operating manual so that you can refer to it later. Our products are being continuously improved. Design changes after going to print may therefore not be considered. - Page 4 English OPERATING AND FUNKTIONAL COMPONENTS CONSTRUCTION, FUNCTION, TECHNICAL DATA Overview: The TwinSweep balimat 2300 is a battery-operated, hand-driven pedestrian-controlled vacuum sweeper fitted with the tandem roller system (TRS). 1 1 13 1 1 22 The TRS allows large sweeping materials to be swept up without difficulty.
-
Page 5: Technical Data
English EN TECHNICAL DATA Technical Data Driving Switching Switching on SAFETY INSTRUCTIONS ON BATTERIES Model balimat 2300 • The operating instructions of the battery manufacturer for Length 923 mm / 37 in their product and the specifications of the legislator on Width 650 mm / 25 in handling batteries are to be followed. - Page 6 English SHUTDOWN / RECYCLING SYMBOLS IN THE OPERATING MANUAL After the useful life of the machine is over, it must be disposed of expertly. However, individual parts may WARNING! CAUTION! DANGER! THE be thoroughly reused. INSTRUCTIONS DESCRIBED MUST BE FOLLOWED For the disposal of all equipment parts, the disposal conditions specific for the location are applicable.
- Page 7 English EN CONTROL PANEL LED CODE GUIDE LED CODE REASON / FAULT SOLUTION One sweeping mode LED is solid Normal operating condition No action required One sweeping mode LED is Motor overload has shut down Disconnect battery cable and flashing fast machine due to obstruction.
-
Page 8: Troubleshooting
English TROUBLESHOOTING Help for faults Possible cause Fault Remedy Device does not start Battery state ≤20% Charge battery Battery cable not correctly connected or loose Check cabling of the batteries and connect correctly Safety switch equipment panel not operated Close equipment panel correctly. Overload or fault with the main relay Check and replace main relay Cause unclear... - Page 9 English EN MAINTENANCE WORK / MAINTENANCE TABLE Instruction: The following maintenance work must be carried out by instructed and authorised specialist staff at the set intervals. CAUTION! In the event that damage to the machine is established, it must not be used until the damage has been remedied by specialist staff.
-
Page 10: Contact Data
English SHUTDOWN, DISMANTLING, DISPOSAL LONG-TERM STOPPAGE OF THE SWEEPER • INSTRUCTION! If it is stopped for a long period, the batteries must charge at intervals of approximately 2 months so they are not damaged by a deep discharge. • Set down the sweeper onto a level, dry and protected surface. - Page 15 û û...
- Page 16 û û û û û û û BEDIENFELD LED-CODEFÜHRUNG - Siehe Seite 7 CONTROL PANEL LED CODE GUIDE - See Page 15...
- Page 18 û û û û > 15 kg / 33 lbs...
- Page 19 û û û û û...
- Page 20 > 15 kg / 33 lbs...
- Page 21 = > 15 kg / 33 lbs Vorwärts-Fahrtrichtung Bewegungsrichtung der Kehrwalzen...
-
Page 25: Electrical Diagram
ELECTRICAL DIAGRAM S2-2 S2-1...
Need help?
Do you have a question about the Taski balimat 2300 and is the answer not in the manual?
Questions and answers