Advertisement
Available languages
Available languages
SAFETY RULES
1.
Charge batteries indoors only.
2.
Keep the battery charger away from rain or
moisture. Penetration of water in the battery charger
increases the risk of an electric shock.
3.
Do not charge other batteries. The battery charger
is suitable only for charging 12 V HAUSSMANN
Ni-Cd batteries. Otherwise there is danger of fire
and explosion.
4. Only charge the battery at an ambient temperature
0
0
between 0
C (32
F) and 45
service life is achieved in this manner.
5.
Keep the battery charger clean. Contamination can
lead to danger of an electric shock.
6.
Before each use, check the battery charger, cable
and plug. If damage is detected, do not use the
battery. Never open the battery charger yourself.
Have repairs performed only by a qualified
technician and only using original spare parts.
Damaged battery chargers, cables and plugs increase
the risk of an electric shock.
7.
Do not operate the battery charger on easily
inflammable surfaces (for example, paper, textiles,
etc.) or surroundings. The heating of the battery
charger during the charging process can pose a fire
hazard.
KNOW YOUR PRODUCT
Read all safety warnings and all instructions. Failure
to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
1
3
4
2
(fig.1)
0
0
C (113
F). A longer battery
The numbering of the product features refers to the
illustration of the tool above:
1.
Battery pack
2.
Battery charger
3.
Red light
4.
Green light
TECHNICAL DATA
Battery type
12V battery pack
Battery model
J0Z-SP13-10108-2
Input voltage
AC120V, 60Hz
Output voltage
Current
Charging
0
0
C(32
temperature range
Charging time
Protection class
OPERATION
1. Charging the battery
The battery is not charged when purchased and must
be charged fully before operation. A new battery, or a
battery that has been stored for some time, may not
initially accept a full charge. This is normal. It will charge
fully after several charge and discharge cycles. The first
charge of a battery pack will take up to 1hour. Subsequent
full charges will also take up to 1 hour. The batteries
should be charged at an ambient air temperature of
between 0
0
C (32
0
F) and 45
To charge a 12 V NiCd battery pack,proceed as follows:
1. Connect the charger to the mains supply and switch on.
The green light stays on. The red light is off.
2. When the battery pack is inserted into the charger,the
red light will flash(frequency=1Hz). The green light
is off.
3. When the battery is fully charged,the green light stays
on and The red light is off.
4. In the event of the failure,the red light will
flash (frequency>2Hz).The green light stays on.
2. Remove the battery
When the battery is fully charged, please remove the
battery pack from the battery charger. Do not leave the
battery in the charger when the charger is plugged in.
6
DC12V
1.3A
0
0
0
F) ~45
C(113
F)
1 hr
0
C (113
0
F).
Advertisement
