Basic Operation; Checking The Sirius Signal Strength And Radio Id; Presetting Radio Channels (Preset Memory) - Denon AVP-A1HD Owner's Manual

Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
<Illustration : AVR-5308CI>
<SOURCE SELECT>
<TUNING PRESET> uio p
[ AMP]
[SAT TU]
(AMP mode)
1

Basic Operation

There is no SIRIUS-dedicated input terminal for AVP-A1HDCI /
AVR-5308CI.
BUTTON
When using an audio input source not used by AVP-A1HDCI /
<BUTTON>
AVR-5308CI, assign SIRIUS to the source.
[BUTTON]
1
Make the necessary preparations.
q Assign the SIRIUS input. q Assign the SIRIUS input.
<STATUS>
: "Source Select" – "(input source)" – "Assign" –
"SIRIUS" (vpage 7)
w C hange the TUNER(DEV2) setting on the main remote control
unit to SIRIUS. unit to SIRIUS.
: "Manual Setup" – "Option Setup" –
"Remote (SIRIUS/XM)" (vpage 5)
2
<SOURCE SELECT>
Either turn
select "SIRIUS".
b When operating via the remote control unit, you cannot select
SIRIUS even by pressing
been assigned.
3
When using the main remote control unit to operate,
[TU]
press to select
[ TU]
( mode) 4
[ ]
Use
When the channel is tuned in, the name of the song and artist
[A ~ G]
are displayed.
[ ]
[MEMO]
• The channel switches continuously when
[ENTER]
and held.
• The song title, artist name, composer name, category and reception
uio p
level can be checked by pressing
[SEARCH]
• The time (default : 30 sec) for which the on-screen display are
displayed can be set at GUI menu "Manual Setup" – "Option Setup" –
[CHANNEL + –]
"GUI" – "Tuner".
• The sub remote control unit can also be used for SIRIUS (vpage
13).
[NUMBER
(0 ~ 9)]
[SAT TU]
or press to
[SOURCE SELECT]
to which SIRIUS has
mode.
to select the channel.
[ ]
is pressed
<STATUS>
.
Checking the SIRIUS Signal Strength
and Radio ID
1
<SOURCE SELECT>
Either turn or press
select "SIRIUS".
b When operating via the remote control unit, you cannot select
[SOURCE SELECT]
SIRIUS even by pressing
been assigned.
2
<STATUS>
Press until "SIGNAL" appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
3
Adjust the position of the antenna until "SIGNAL:
EXCELLENT" is shown on the display.
4
<STATUS>
Press until the channel (example: "SR001")
is displayed.
5
[ ]
Press and select channel 0 (SR000).
Channel No. and Sirius ID are alternately shown on the display.
Sirius ID
SR000 SiriusID
************
b Write your own SIRIUS ID for storage use.
Sirius ID :
The strength of both the SIRIUS satellite and terrestrial signals can
be checked at GUI menu "Source Select" – "SIRIUS" – "Antenna
Aiming" (vpage 6).
Presetting Radio Channels
(Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
[MEMO]
Press .
[SAT TU]
to
to which SIRIUS has