Axxess AXDSPL-HD2 Installation Instructions Manual

Harley davidson dsp package with water resistant enclosure 2014-up

Download this manual

INTERFACE COMPONENTS

• AXDSP-L circuit board

• AXDSPL-HD2 harness (with gaskets)

• AXDSPL-HD2 enclosure

• Case

• Cap (with O-ring)

AxxessInterfaces.com

Harley Davidson DSP

Package with Water

2014-Up

Resistant Enclosure

INTERFACE FEATURES

• AXDSP-L included

• Water resistant enclosure with zip tie mounts included

• Amplifier, if equipped, does not need to be retained

• All wiring will be done at the radio location

• Micro-B USB updatable

AXDSPL-HD2

I N S T A L L A T I O N I N S T R U C T I O N S

TABLE OF CONTENTS

Connections ............................................................2

Installation ......................................................... 3-4

TOOLS & INSTALLATION ACCESSORIES REQUIRED

• Crimping tool and connectors, or solder gun,

solder, and heat shrink • Tape • Wire cutter

• Zip ties

Product Info

REV. 3/23/20 INSTAXDSPL-HD2

Page 1 • Amplifier, if equipped, does not need to be retained • All wiring will be done at the radio location • Micro-B USB updatable INTERFACE COMPONENTS • AXDSP-L circuit board • AXDSPL-HD2 harness (with gaskets) Product Info • AXDSPL-HD2 enclosure • Case • Cap (with O-ring) AxxessInterfaces.com...
Page 2 Locking clip shown in unlocked position 16-Pin 20-Pin Additionable Outputs Gasket For Optional Amps AXDSPL-HD2 Harness AXDSPL-HD2 Harness An SPDT relay, Metra part number E-123, must be used if the amp turn-on current of all amps exceed 1-amp. Blue/White - Amp Turn-On...
Page 3 3. With the arrow stamped onto the cap facing upwards, push the 16-pin connector from AXDSP-L the AXDSPL-HD2 harness into the left side of the cap. The locking clip on the connector Circuit Board should face upward. Make sure the gasket is seating properly in the cap. (Figure A) 4.
Page 4 10. Connect the amp turn-on wire from the AXDSPL-HD2 harness. 11. Click the Identify button to confirm that the AXDSPL-HD2 is connected properly. If so, a chime will be heard from the front left speaker. Test all functions of the installation for proper operation.
Page 5 REV. 3/23/2020 INSTAXDSPL-HD2...
Page 7 REV. 3/23/2020 INSTAXDSPL-HD2...
Page 8 AXDSPL-HD2 I N S T A L L A T I O N I N S T R U C T I O N S Having difficulties? We’re here to help. Contact our Tech Support line at: 386-257-1187 Or via email at: techsupport@metra-autosound.com...