1830 Instructions
7/16/03
To Make the First Bag from the
Polyethylene Roll
1. Make sure that the selector switch is in the
Cut-Bag
2. Pull the plastic out over the sealing wires
(Figure 2). The roll is folded into a double layer
to form the bottom seal of each bag.
3. Lower the lid and then press down firmly on
the lid with both hands to activate the sealing
mechanism. Both the red (VACUUM) and
green (SEAL) lights will turn on (Figure 3).
4. After the green (SEAL) light goes off, (in about
10-15 seconds), lift the lid and tear away the
excess plastic at the beginning of the roll.
5. Next, create a custom-size bag by pulling the
amount of plastic you need from the roll and
out over the sealing wires.
6. Repeat the sealing process in Step 3. When the
green (SEAL) light goes off, pull the bag away
from the sealing wires. You now have a bag
sealed on three sides, ready to be filled and
vacuum sealed.
3:39 PM
Page 5
position.
To Make Additional Bags
from the Roll
After the roll is started, you only need to seal
one side to create each additional bag. The first
side will be sealed from previous sealing action.
To make each additional bag, simply pull out the
amount of plastic needed from the roll over the
sealing wires and press down to activate the
sealing mechanism. When the green (SEAL) light
turns off, simply peel the plastic from the wire and
you will have your bag.
To cut and seal a side of the bag, press down firmly
on the lid with both hands.
FIGURE 3
5