Table of Contents
Advertisement
Packing/Unpacking
Inspect the shipping container for evidence of damage
immediately after receipt. If the shipping container or
cushioning material is damaged, it should be kept until
the contents of the shipment have been checked for
completeness and the camera has been checked
mechanically and electrically.
The shipping container should be placed upright and
opened from the top. Remove the cushioning material
and lift out the contents.
The contents of the shipment should be checked
against the packing list. If the contents are incomplete,
if there is mechanical damage or defect, or if the
camera does not perform correctly when unpacked,
notify your Thomson Multimedia Broadcast Solutions
sales or service centre within eight days. If the
shipping container shows signs of damage or stress,
notify the carrier as well.
Transport
If the unit is being returned to Thomson Multimedia
Broadcast Solutions for servicing, try to use the
containers and materials of the original packaging.
Attach a tag indicating the type of service required,
return address, model number, full serial number and
the return number which will be supplied by your
Thomson Multimedia Broadcast Solutions service
centre.
4
Technical Manual LDK 4628 - Operational Control Panel
If the original packing can no longer be used, the
following general instructions should be used for
repacking with commercially available materials:
a. Wrap unit in heavy paper or plastic.
b. Use strong shipping container.
c. Use a layer of shock-absorbing material around all
sides of the unit to provide firm cushioning and pre-
vent movement inside container.
d. Seal shipping container securely.
e. Mark shipping container FRAGILE to ensure care-
ful handling.
Storage
The unit may be stored (non-operating condition) in
environments within the following limits:
Temperature:
-20 to +50 degrees C
Humidity:
up to 90%
Altitude:
50,000 feet
When stored, the unit should be protected from
temperature extremes which may cause condensation,
and should also be protected from high levels of dust.
02.33.2
Advertisement
Table of Contents
