Delphi SA10112 Installation Manual page 3

1. Connect the antenna cable leading
from the accessory into the
antenna-in jack.
2. Connect the vehicle antenna
cable lead from the accessory
with vehicle antenna cable
(adaptor may be required).
3. Connect the vehicle radio cable
lead with the vehicle radio cable
(adaptor may be required).
4. Connect the XM Antenna into
the jack located on the side of
the accessory.
5. Your XM FM Direct Accessory can
be powered by connecting the
6V power adaptor with either an
existing cigarette lighter, or for a
more attractive installation the
power socket (included) may be
wired directly to the vehicle's power
system. In that case, professional
installation is recommended.
Note: The FM antenna connector used to connect
the FM modulator to the audio/stereo system may
require an additional adaptor. Some audio/stereo
systems have AM antennas that require an active
bias from your vehicle's audio/stereo system. If AM
reception is not restored, try a different adaptor
that will allow the active bias to reach the AM
antenna. Professional installation is recommended.
The Delphi XM FM Direct Accessory
may be tie wrapped to existing wire
harnesses or other under-dash
structures, or placed under a seat.
The accessory should be constrained
in some way to help prevent it from
causing annoying rattles or other
noise and/or chafing.