Explanation Of Symbols; Operating Instructions; Overview; Before First Use - CALIMA 46038 Operating Instructions Manual

• The battery is firmly installed in the power bank with solar function, and cannot be replaced.
• Please also refer to the safety notices and operating instructions of the devices which you connect to the power bank with solar
function.
• Protect the power bank against mechanical stresses (falling, pressure, distortion, etc.).
• If the safe use of the power bank is not guaranteed, the device should not be used, and should be protected against accidental
use. Safe use is not guaranteed if the device is visibly damaged, or no longer functions perfectly.
• The connecting cables must not be kinked, squeezed, stretched or damaged in any other way.
• Never simultaneously charge and discharge the power bank, as this may damage the battery. (Never connect the power bank
to a USB device during charging.)
• For your own safety, only use accessories and spare parts which are stated in these instructions or which are recommended by
the manufacturer!
• Never look directly into the light source and never direct the beam of light onto people or animals. The LED light may result in
injuries to the eyes.
• Never look at the light source using optical instruments. The LED light may result in injuries to the eyes.
• Place the power bank on a heat-resistant surface during operation.
• Do not leave the power bank unattended during operation.

5. EXPLANATION OF SYMBOLS

Complies with EC directives
Read the operating
instructions.

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

1 Charge status display
2 Switch
3 Solar panel
4 USB output
5 LED torch
6 USB output
7 Micro USB input
8 USB cable
9 USB A plug
10 Micro USB B plug

6.2 BEFORE FIRST USE

Before using the power bank with solar function for the first time, it should be fully charged with a charging device. See Section
6.3.

6.3 CHARGING WITH A CHARGING DEVICE

Protect the solar panel from strong sunlight when charging the power bank with a charging device. The internal battery may
overheat.
Disconnect all connected devices from the power bank before charging.
For charging, use a USB charging device with a charging current of 1 A. Remove the rubber cap from the left-hand side of the power bank. Connect
the micro USB B plug (Position 10 in the overview) of the USB cable (Position 8 in the overview) to the micro USB input (Position 7 in the overview)
of the power bank. Connect the USB A plug (Position 9 in the overview) to a USB charging device. Connect the charging device to a socket. The
charge status display (Position 1 in the overview) is activated, and lights up blue. The charge status display consists of four individual lamps. The
Labelled electrical products may not be
disposed of in the household waste
Devices with this symbol may only be
operated indoors (dry environment).
Figure 1: Overview