Delphi Roady 2 SA10109-11P1 Quick Manual page 2

Setting up Your Roady2 ™
Personal Audio System
Note: Before using your Roady2 Personal
Step 1:
Audio System for the first time, it is
Push down the latches on
recommended that you fully charge
both sides.
the battery. See your
Roady2 Personal
Audio System
User Guide
for more
information.
Step 2:
Slide the tray out.
Step 5:
Step 3:
Slide the mode switch to XM or FM.
Gently place your Roady2 into
the docking station and slide the
Important: For Roady2 operating instructions,
tray back in until latches click.
consult the Roady2 User Manual that came
with your Roady2.
Step 6:
Step 4:
Remove your Roady2 by pushing down
Plug in your headset.
the latches on both sides and sliding
Caution: Turn down the volume before
the tray outward.
using headset to avoid ear damage.
Mode switch
Important Things
to Know
Display
The Roady2 Personal Audio
System display shows the
mode (FM or XM), FM
station, battery charge indicator,
and volume. (XM channels
appear on your Roady2 display.)
Backlight
Any time you adjust the controls
or change modes, the blue
LED backlight comes on so
you can easily read the display.
Roady2 setup
See page 5 of your Roady2
User Guide for important setup
information.
Headset
Your Roady2 Personal Audio
System headset not only
produces great sound, it
contains a built-in antenna.
Keep the antenna in line of
sight with the satellite for best
reception. You can adjust the
volume with the control on
the right side.
Battery pack
To recharge the battery, plug
the AC adaptor into the unit
with the battery in place. The
Lithium Ion battery will fully
charge in about two hours
when the unit is turned off, but
you can charge it while using it.
The indicators at the upper left
part of the display indicate the
state of the battery.