Using The Setup Password - Dell PowerEdge 860 Information Update

Table 1. System Board Connectors (continued)
Item Connector
3 PWR_CONN
4 DIMM1_A
5 DIMM2_A
6 DIMM1_B
7 DIMM2_B
8 FAN
9 BATTERY
10 SATA_0
11 SATA_1
12 PCI_FAN
13 FP_CONN1
14 IDE
15 HD_ACT_CARD
16 INTRUSION_SWITCH
17 RISER_CONN1

Using the Setup Password

When a setup password is enabled for the System Setup program, the system gives you one chance to
enter the setup password correctly. If you enter the password incorrectly, the system displays an error
message and opens the System Setup program for viewing only. You will not be able to change any of
the System Setup fields except for the system password. If you have already entered the system password
during the current session, you can change the system password if the Password Status field is set to
Unlocked. To change the Password Status field from Locked to Unlocked, you must enter the correct
setup password.
__________________
Information in this document is subject to change without notice.
© 2006 Dell Inc. All rights reserved. Printed in Malaysia.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc. Other trademarks and trade names may be used in
this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any proprietary interest
in trademarks and trade names other than its own.
Description
Power supply connector
Memory module
Memory module
Memory module
Memory module
Fan power connector
3.0 V coin battery connector
SATA 0 hard drive connector
SATA 1 hard drive connector
PCI fan connector
Control panel interface connector
Optical drive interface connector
Hard drive activity connector (expansion controller)
Connector for the chassis intrusion switch
Riser card interface connector